genexis XGS2110-2.5G FiberTwist-Series Installation Guide
- June 5, 2024
- genexis
Table of Contents
genexis XGS2110-2.5G FiberTwist-Series
Button overview
Port overview
ON/OFF button
Power ON or OFF – press and release to switch device ON or OFF
LED overview
Installation guide
Different language versions of this document and additional product information are available on https://genexis.eu/product/fibertwist/downloads
Box contents
- Genexis FiberTwist (active device)
- Power adapter
- 2x Spare device label (self-adhesive)
- Installation Guide (this document)
Label position
The product label is positioned on the back of the active device.
Preparation
Ensure there is a power socket within reach of where the device is being
installed.
Important: Instructions need to be followed precisely and uninterrupted. This minimizes the risk of damage to the fiber optic connectors, causing a severe degradation of signal quality.
Remove Biind Cover (if present)
- Press and hold the unlock button (see button overview).
- Rotate the Blind Cover counterclockwise till it blocks.
- Remove the Blind Cover from the baseplate (FTU) by pulling it towards yourself.
- Store the Blind Cover in a safe place.
Remove dust cap
- Take the FiberTwist out of the box.
- The dust cap is connected to the red string located on the rear of the FiberTwist.
- Remove the dust cap by pulling the red string.
- Store the dust cap in a safe place.
Twist!
- Place the FiberTwist on the FTU as shown in the picture below, in a 30-degree angle.
- Rotate clockwise until it clicks into place
- Make sure the Fiber Twist is aligned squarely on the FTU, each edge must line up directly with the FTU below. Your Fiber Iwist is now installed!
Connecting the FiberTwist
- If required, connect your personal devices to the LAN ports via an RJ45 network cable.
- Connect the supplied power adapter to the Fiber Twist and plug the adapter into a power socket.
- Press the ON/OFF button to power on the device.
If at some point in the future it becomes necessary to uninstall the Fiber Twist, please place the Blind Cover back on the FTU immediately and put the dust cap back on the FiberTwist.
Warning: The Fiber Twist is a Class 1 laser product.
EU Declaration of Conformity
Hereby, Genexis Netherlands BV. declares that the product Fiber Twist- XGS2110-2.5G is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, Delegated Directive 2015/863 and Ecodesign Directive 2009/125/EC. The full text of the EU declaration of conformity is available at the following internet address: https://genexis.eu/product/fibertwist/red /fibertwist-xgs2110-2-5g
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>