genexis XGS2472 FiberTwist Series Device Installation Guide
- June 5, 2024
- genexis
Table of Contents
genexis XGS2472 FiberTwist Series Device Installation Guide
LED oveview
Button overview
Port overview
Reset button (recessed)
Reboot – short press (up to 10 seconds)
Factory reset – long press (more than 10 seconds)
ON/OFF switch
Switch ON – flip the switch to ON
Switch OFF – flip the switch to OFF
Installation guide
FiberTwist XGS2472 is installed on an FTU/Bracket
Various translations of this document (if available) and additional product information can be found on https://genexis.eu/product/fibertwist/downloads
Box contents
- Genexis FiberTwist XGS2472
- Power adapter
- Labels (self-adhesive)
Label
More information can be found on the product label which is positioned on the
bottom of the active device.
Preparation
Ensure there is a power socket within reach of where the device is being
installed.
Important: Instructions need to be followed precisely and uninterrupted. This minimizes the risk of damage (a severe degradation of signal quality) to the fiber optic connectors
Remove Blind Cover or active device (if present)
- Press and hold the unlock button (on the right side of the Blind Cover or active device).
- Rotate the Blind Cover or active device counterclockwise till it blocks.
- Remove the Blind Cover or active device from the baseplate (FTU/Bracket) by pulling it towards yourself.
- Store the Blind Cover or active device in a safe place.
Remove dust cap
- Take the FiberTwist XGS2472 out of the box.
- The dust cap is connected to the red string located on the rear of the FiberTwist XGS2472.
- Remove the dust cap by pulling the red string.
- Store the dust cap in a safe place.
Twist!
- Place the FiberTwist XGS2472 on the FTU/Bracket as shown in the picture below.
- Rotate clockwise until it clicks into place.
- Make sure the FiberTwist XGS2472 is aligned squarely on the FTU/Bracket.
Your FiberTwist XGS2472 is now installed!
Connecting the FiberTwist
-
If required, connect your television / set-top box to the TV port with a coax cable.
-
If required, connect your personal devices to the LAN ports via an RJ45 network cable.
A CAT6 cable or better is recommended. -
Connect the supplied power adapter to the FiberTwist and plug the adapter into a power socket.
-
Press the ON/OFF button to power on the device
If at some point in the future it becomes necessary to uninstall the FiberTwist, please place the Blind Cover back on the FTU/Bracket immediately and put the dust cap back on the FiberTwist.
The FiberTwist is a Class 1 laser product.
EU Declaration of Conformity
Hereby, Genexis Netherlands B.V. declares that the radio equipment type FiberTwist XGS2472 is in compliance with Directive 2014/53/EU, Directive 2009/125/EC, Directive 2011/65/EU and Delegated Directive 2015/863.
The full text of the EU declaration of conformity is available at the following internet addresses: https://genexis.eu/red/ft-xgs2472
Company Name
Genexis Netherlands B.V.
Company Address
Lodewijkstraat 1a
5652 AC Eindhoven
The Netherlands
Name and title of authorized person
Maarten Egmond, CTO
Signature of authorized person
Place of issue
Eindhoven
The Netherlands
Date of issue
2022-01-12
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>