F U CD-3591BT Digital Car Audio System with Bluetooth Instruction Manual
- June 5, 2024
- F U
Table of Contents
F U CD-3591BT Digital Car Audio System with Bluetooth
IMPORTANT NOTICE & PRECAUTIONS
Thank you for using our product! To operate the unit correctly, please read the operation manual carefully before using.m The unit is designed only for DC12V negative ground operation system. Make sure your vehicle is connected to a DC12V negative ground electrical system. Be sure to connect the speaker (-) leads to the speaker (-) terminal. Never connect the left and right channel speaker wires together or to the vehicle body. The normal temperature for operation is between -20 and +60 degree Celsius. Do not work in extreme high or low temperature and block vents or radiator panels of the unit, blocking them will cause heat to build up the unit and may cause damage or fire. This unit can play the following discs (12cm) and media files: CD-R/RW/MP3/WMA.
INSTALLATION
Accessories included in the package for installation
Mounting Method A
- Put the mounting sleeve (1) into the dashboard
- Band the tabs of the mounting sleeve (1) outward into the dashboard for a secure mounting.
- If necessary, use the strap (6) to secure the back of the unit in place. The strap (6) can be bent by band to the desired angle. To remove the unit, insert the release keys (2) on both sides of the unit out from the dashboard.
Mounting Method B
This mounting method is used for most japanese cars. The actual mounting method should depend on the type of cars and the supplied parts.
Note:
- Store small articles in places not accessible to children.
- Install only with the supplied screws.
- Installation varies on type of cars and supplied parts.
- The unit should be installed by a qualified technician.
To Detach the Front Panel
Front panel
Before detaching the front panel, make sure to turn off the unit. Press the release button and pull off the front panel.
To replace the Front Panel
First, insert the right hand side of the front panel into the main unit. Then push the left hand side of the front panel into the main unit it locks firmly.
WIRING CONNECTION
BACK OF MAIN UNIT
MAIN UNIT OPERATION
-
PWR: Press to turn on or off of the unit. When the unit is turned off, press to turn on the unit.
-
IR: Remote control sensor (for signal reception from remote handset).
-
detach: Press to detach the removable front panel from the main unit.
-
LCD DISPLAY: It shows the status of current operation of the unit.
-
FUNCTION CONTROL: Rotate to adjust sound output level.
- Audio Control: Press repeatedly to activate following control modes & when the desired mode reached,press VOL+/VOL-(18) to set or adjust: Bass (BAS) / Treble (TRE) / Balance (BAL) / FAD / LOUD-OFF (LOUD-ON) / EQ-OFF (FLAT/ROCK/POP/CLASSIC/JAZZ /EQ OFF) / STEREO (MONO) / DX(LOCAL) / Volume(VOL)
- Function Control: Press & hold for 2 seconds to activate various function control. At this mode,press SEL(5)&VOL+/VOL-(18) to have the following settings and controls:
-
MUTE: Press turn on or off the sound muting control.
-
phone: At bluetooth mode, press to hang up or refuse an incoming call.
-
call: At bluetooth mode, press to dial out a phone or pick up a call.
-
CLK: Press to recall time display. Press & hold for 2 seconds to activate clock setting mode and hour digit start blinking. At this mode, rotate & press function control to adjust hour and minute. After setting, press to confirm the setting.
-
MODE: Press to select desired mode for operation.
-
USB: Insert USB device to this slot for digital files playback.
-
SD: Insert SD/MMC card to this port for digital files playback.
-
AUX: Insert an external device to this jack in order to have output of the external device through the unit.
-
DISC SLOT: Insert or remove disc from the disc slot.
-
disc: Press to eject disc from the disc slot.
-
BAND: Radio Mode Press to select the desired radio band for broadcasting. Disc/USB/SD Input Mode Press to display ID3 contains of the MP3 files that recorded in the device.
-
APS: Radio Mode Press shortly to scan all the preset stations on selected radio band and stop several seconds for broadcasting. Press and hold for 2 seconds to start search & storing the strongest signal stations into the PRESET MEMORY STATION 1-6. Disc/USB/SD Input Mode Press repeatedly to activate different searching modes that may include directory, file, track & time search. Under this mode, rotate & press FUNCTION CONTROL to select track for playback.
-
radio: Radio Mode (SEEK 1 Mode) Press to start automatic seeking frequency upward or downward to the next strong station received. Press & hold for 2 seconds to activate manual turning mode. At this mode, press repeatedly to tune the radio frequency upward or downward. Radio Mode (SEEK 2 Mode)
Press repeatedly to turn radio frequency upward or downward. Press & hold for 2 seconds to start automatic seeking frequency upward o downwards to the next strong station received. Radio Mode (SEEK 3 Mode) Press repeatedly to turn radio frequency upward or downward. Press & hold to turn the frequency upward or downward and release when your desired frequency is reached. Disc/USB/SD Input Mode: Press to shift track upward or downward for playback. Press & hold to start fast forward or fast rewind of the track. -
PRESET MEMORY STATION (NO.1-6): At radio mode, press any one of the preset number to select a station that had been stored in the memory. Press and hold for 2 seconds of any one of the preset number can store the current broadcasting station in the memory.
-
PAU: At disc/USB/SD input mode, press to start or pause playback
-
INT: At disc/USB/SD input mode, press to start into playback of each track for 10 seconds.
-
RPT: At disc/USB/SD input mode, press to select repeat playback mode.
-
RDM: At disc/USB/SD input mode, press to select start random playback of the device.
-
-10: At disc/USB/SD input mode, press each time to select every 10 tracks downward for playback.
-
+10: At disc/USB/SD input mode, press each time to select every 10 tracks upward for playback.
Note: Depends on different type of discs and media files that recorded, not all operations as described in the above operation manual can be functioned.
REMOTE HANDSET OPERATION
BATTERY REPLACEMENT
Refer to the back of remote handset for details on how to replace the
batteries.
- power: Press to turn on or off of the unit.
- BND:Radio Mode Press to select the desired radio band for broadcasting. Disc/USB/SD Input Mode Press to display ID3 contains of the MP3 files that recorded in the device.
- Mode/0: Mode switch. Press once to switch Radio-CD-BT-Aux in modes. Bluetooth mode: Press to is the 0 number key.
- sound on/off: Press to turn on or off of sound (muting control).
- sel: At bluetooth mode, press to is the #key.
- radio mode: Radio Mode Press to start automatic seeking frequency upward or downward to the next strong station received. Press & hold for 2 seconds to activate manual tuning mode. At this mode, press repeatedly to tune the radio frequency upward or downward.
- incoming call: At bluetooth mode, press to hang up or refuse an incoming call. Deletes the effect when a number is entered.
- playback: At disc/USB/SD Input mode, press to start or pause playback. At Bluetooth Mode, press to is the 1 number key.
- each track: At disc/USB/SD input mode, press to start into playback of each track for 10 seconds. At Bluetooth Mode, press to is the 2 number key.
- number key: At disc/USB/SD input mode, press to select repeat playback mode. At Bluetooth mode, press to is the 3 number key.
- input mode: At disc/USB/SD input mode, press to select start random playback of the device. At Bluetooth mode, press to is the 4 number key.
- each time: At disc/USB/SD playback mode, press each time to select every 10 tracks upward for playback. At Bluetooth Mode, press to is the 5 number key.
- 6/+10: At disc/USB/SD playback mode, press each time to select every 10 tracks downward for playback. At Bluetooth Mode, press to is the 6 number key.
- 7/AF: At Radio Mode, press to turn on or off AF. At Bluetooth Mode, press to is the 7 number key.
- TA/8: At Radio Mode, press to turn on or off TA. At Bluetooth Mode, press to is the 8 number key.
- PTY/9: At Radio mode, press to station type selection of PTY. At Bluetooth Mode, press to is the 9 number key.
- CLK/: Time view and time adjustment. At Bluetooth Mode, press to is the key.
- VOL+/VOL-: Press to adjust sound output level.
- dial out: At Bluetooth Mode, press to dial out a phone or pick up a call.
- PRESET: At radio mode, press any one of the preset number to select a station that had been stored in the memory. Press and hold for 2 seconds of any one of the preset number can store the current broadcasting station in the memory.
Note: Depends on different type of disc and media files that recorded, not all operation as described in the above operation manual be functioned.
MAIN UNIT – BLUETOOTH OPERATION
MODE SELECTION
During unit operation, press MOD(1) repeatedly to select the Bluetooth
operation mode.
MICROPHONE
During installation of unit, connect the microphone to the microphone jack at
the back of the main unit.
LINK UP WITH MOBILE PHONE
To link up the Bluetooth with the mobile phone, take your phone and follow
these steps: -turn on the Bluetooth operation of your mobile phone
- start to search new device on your mobile phone
- after searched, new device “CAR AUDIO” searched out, confirm the search
- input the default code “0000” in your mobile phone and confirm the setting
- “BT ON” will appear shortly on LCD DISPLAY(4) when the linked-up succeed
CONNECT / DISCONNECT WITH MOBILE PHONE
When Bluetooth has been connected with mobile phone, once a call is received
or dial, the unit will be responded automatically and switched to Bluetooth
operation. The unit will be resumed to its original mode when the phone
hanged-up.
CALL PICK UP
When a call is received, the caller ID(if available on the incoming call) will
be appeared on the LCD DISPLAY(4). Press (11) to pick up the call.
DIAL OUT
When a phone number is dial out, “CALLING” will be appeared on LCD DISPLAY(4).
HANG UP/REFUSE CALL
Press (1) to hang up or refuse an incoming call. The unit will resume to its
original playing mode.
MUSIC PLAYBACK
At Bluetooth operation mode and when mobile phone is connected, music playback
from the mobile phone will be transmitted to the unit for broadcasting.
NOTE
Bluetooth operation on the main unit is confined to call pick up, call hang
up, refuse call and music playback only.
SPECIFICATIONS
- Power Requirement: DC 12Volts, negative ground
- Load Impedance: 4 Ohms
- Maximum power Output: 40 watts x 4channels
FM RADIO SECTION
- Frequency Range: 87.5-108MHZ(Europe)
DISC SECTION
- Disc Play: CD/MP3/WMA
- Mounting Angle: ±30 degree
AUDIO SECTION
- Maximum Output Level: 2 Vrms(+/-3 dB)
- Frequency Response: 20 Hz to 20 Khz
- Signal to Noise Ratio: 85dB
- Channel Separation: 80dB
Note: Specification and design; functions and features; unit illumination; color and display segment are subject to change without pior notice. Photos and drawings on gift box or operation manual might be varied from the exact unit. Depends the input device, operation might be varied from the operation manual described.
SIMPLE TROUBLESHOOTING GUIDE
| Problem | Cause/Solution |
|---|---|
| No power | Check and make sure whether the fuse is blown; replace with the |
proper fuse if necessary.
Some errors occur in the LCD
No function when pressing the button
| Press the RESET button.
Unable to receive stations| Check and make sure whether the antenna is
inserted or the antenna is properly connected. If not, insert or connect it
properly.
Poor effect on receiving a station| Antenna may not have the proper length.
Make sure the antenna is fully extended without damages. If broken, replace
the antenna with a new one.
The broadcasting signal is too weak.
The antenna is poorly grounded. Check and make sure the antenna is properly grounded at its mounting location.
A disc cannot be loaded “ ”
| ****
A disc is already loaded in the mechanism.
The stereo indicator is flashing| Tune in the frequency accurately.
The broadcasting signal is too weak (set to the MONO mode).
Noise| The disc is dirty or damaged.
Unable to use Bluetooth| Check if the Bluetooth mobile is correctly connected
with this machine, refer to mobiles instruction and pair again.
Too much Echo
| While communication voice is too loud, adjust voice lower (down).
In Bluetooth status, while listening to mobile music or communication, voice
might be heard intermittently| ****
Bluetooth is too far away from the unit. Place the mobile near the unit – it should be within 5 meters.
Note: if you still cannot solve the problems with these solutions, please ask the dealer for help. Please do not dismantle the device.
NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please dispose of this equipment at your local community waste collection/ recycling centre. In the European Union there are separate collection systems for used electrical and electronic products. Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the
requirements of below directives:
RED Directive: 14 / 53 / EU
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU & Delegating Directive (EU) 15 / 863 The detailed
declaration of conformity can be found at www.united-
electronics.gr
Exclusive importer in Greece: Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534 Thessaloniki – Greece
T: +302310944944 | F: +302310944940
www.amiridis-savvidis.gr
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>