LENOXX KB922 61 Key Electronic Keyboard Instruction Manual
- June 5, 2024
- lenoxx
Table of Contents
LENOXX KB922 61 Key Electronic Keyboard
Product features,
- Support switching back and forth across devices
- Three·system mod@ switching: the mainstream equipment of the general market
- Bluetooth S.O is b@tter compatible with new and old devices
- Connect vel$iOn S.O to hibernate and wake up faSter
- W,the high-frequency equipment switching, the keyboard works smoothly
CONNECTION DESCRIPTION
-
Tum the power switch to ON to ium on the keyboard
-
4G mode; (system default}
Take out the USB re<:eiver and plug it into the computer -
Bluetooth mode:
Press and hold FN. then press 1. and then press and hold for 3 seconds, the blue light flashes.and Bluetooth dev,ce 1 enters the searched state on the device ide-open the tern :;ettmgi-tum on 81uetootll-$earch end
Multi-device connection
- FN + 1: connect Bluetooth device
- FN +2: conne<:t Bluetooth device 2
- FN +3: connect Bluetoolh device 3
- FN + -connect U$8,2.4G wlfele$$ ,_1v1n9
- FN + L2.3, – combination single press; you can switch the paired devices
- fN +l,2.3combined lor,g pre$$ f01 3 second$: flashing light, C<ln start Ifie searched s1a1e (connect new 1Mtuipmen1)
Connection supplement
- The initial conn@C!ion k@)’board nl! eds 10 switch ! he devises to 1he corresponding system
- he system is not switched, the function key may 001 v,o,k nonnally’
- The new distance of \eyboard,s 5-lOrn. and the distance is r! related to different equipment and environmental factors
FN combination function key
Troubleshooting
- When the keyboard can’t be searched, try Bluetooth on the switch device to search again
- When the keyboard is turned on and there is no indicator light, try to charge the keyboard
- After connecting other devices, you used to delete the old re<:ords beforecoone<: ting back 10 the original devices
- When the pairit19 !ails, the failed pairi09 reco,d needs to be deleted and the second pairing is performed
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>