competec Allora Electric shaver fast shave Instruction Manual
- June 5, 2024
- Competec
Table of Contents
competec Allora Electric shaver fast shave
INSTRUCTION MANUAL
Electric shaver
Charging
- Charging time 8 hours
- Battery life in operating mode 60-80 min
- Charging current: 5V – 1A
- Switch the shaver to the „OFF“ position before charging. Connect the cable to the shaver and a live USB interface (e.g. PC) or a USB adapter. The indicator light is red when connected to the power source and changes to green when the shaver is fully charged.
Application
-
Remove the protective cover.
-
To use the eyebrow shaver, slide the switch towards the eyebrow shaver.
To use the face shaver, slide the switch in the other direction. -
Pull the skin a little taut. Place the desired shaving head straight on the skin. Move it slowly back and forth over the dry skin.
-
Slide the switch to the centre to switch off the appliance.
Loosening the shaving heads
Hold the handpiece in one hand and twist the shaving head off the attachment.
ATTENTION: The face shaver must be turned clockwise, the eyebrow shaver
counterclockwise. Please pay attention to the direction of rotation so as not
to damage the shaving head. To put it on, turn the shaving head firmly on the
attachment.
Cleaning
Remove the shaving head from the attachment. The handpiece must not be
immersed under water, otherwise, the electronics may be damaged.
Clean the shaving heads regularly under warm water. Remove loose hair in the
attachment with the small brush provided. The handpiece can be cleaned with a
damp cloth. Do not use any harsh or corrosive cleaning agents. Please allow
the shaving heads to air dry before placing them on the attachment or storing
the appliance.
Safety Instructions
- Do not use in the bath or shower. If the shaver does come into contact with water, please disconnect it immediately from the power supply.
- Before cleaning, please switch off and unplug the shaver.
- This appliance is for domestic use only.
- Keep the shaving kit away from children.
- This appliance may be used by persons with reduced physical, sensory or mental abilities or lack of experience and knowledge, provided they are supervised during use and have understood the dangers. Children are not allowed to play with the shaving set.
- Cleaning and maintenance must not be carried out by children.
- Use this appliance only for its intended use as described in this manual.
- Do not use the razor on your scalp, synthetic hair or animal fur.
- Never use accessories or parts from third-party manufacturers as this will invalidate the warranty.
- Do not use this appliance with a damaged or broken cutter, as this may result in injury. Always make sure that the blades are correctly aligned.
- Do not use this product in case of malfunction, if it has been damaged or has fallen into the water.
- Insert the nasal hair remover very carefully into the nose and do not exert pressure to avoid injuries.
- If you experience pain or discomfort when using LIBERTY, stop using it immediately.
- Always clean the attachments after use. For reasons of hygiene, the device should only be used by one person or disinfected after or before each use.
Technical data
charging current: 5V – 1A
battery: 600mA Ni-mAh
battery voltage: 1.2V / 3W
Disposal
The product must not be disposed of together with normal household waste.
Follow the local regulations for the separate disposal of electrical and
electronic products.
Proper disposal will help prevent negative effects on the environment and
health.
Manufacturer
VEHNSGROUP GmbH
Theatinerstrasse 40-42
80333 Munich
Germany
service@vehnsgroup.com
www.vehnsgroup.com
www.ailoria.de
MADE IN CHINA
Changes and errors excepted
The manufacturer accepts no liability resulting from incorrect, improper or
incompatible use of the product.
© VEHNS GROUP GmbH
Version 2.0 – 04/2021
VEHNSGROUP GmbH, Theatinerstrasse 40-42 80333 Munich, Germany
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>