Shenzhen Aoni Electronic C013 Bluetooth Dongle User Manual

June 5, 2024
Shenzhen Aoni Electronic

Bluetooth Dongle C013 C013

Overview

Basic operation functions

  1. Power on: USB After inserting the USB interface into the computer equipment for power supply, it will start automatically
  2. Power off: USB Unplug the USB and turn it off.
  3. Pairing: After the computer is plugged in and turned on, it automatically enters the pairing state and searches for nearby Bluetooth earphones
  4. Loopback connection: The Bluetooth headset can be connected back after the USB is reinserted into the computer and then the headset is turned on or the USB is reinserted into the computer after the headset is turned on, or after the connection distance is exceeded and the USB is returned to the connection distance (within the linkloss time range of the headset)

The indicator light

  1. Power on: Green lights flashing
  2. Power off: Green lights goes off
  3. Pairing status/Unconnected status: Green lights flashing
  4. Connected state: Green light normally on\
  5. Dongle: The Dongle is red when the headset is silent and green when the headset is not silent.

Bluetooth pairing and connection

A.  For first use, insert C013 into computer equipment, power on, and enter pairing state (green light flashing)
B. Then turn on the bluetooth headset and try to get close to C013. It will be automatically paired in about 30S. If it has been paired, the Bluetooth headset will automatically connect to the paired C013 each time it is turned on.
C. When playing music or making a phone call on the computer, the Bluetooth headset can hear the music or make a normal conversation.

Product specifications

etooth specification Bluetooth 5.0
Operation frequency 2.402-2.480GHz
Supported profile A2DP HFP  AVRCP
Chip solution ATS2831
Operation range UP to 10 meters
CODEC SBC
Net weight 2g
Measure 2515.155mm
Operating temperature -10—55℃
Operating voltage range 5.0±0.25V

***** The above data are from Oni lab, the actual use time and environment and music may vary

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to
  • which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals