FIAMMA 98655-747 F35 Pro Awning Adapter Kit Instruction Manual
- June 5, 2024
- FIAMMA
Table of Contents
FIAMMA 98655-747 F35 Pro Awning Adapter Kit Instruction Manual
Package contents
Tools Needed
Dimension
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
Installation instructions
ATTENTION: INSTALLATION ON FIXING KIT
The brackets must always be well-aligned to each other to avoid later
problems; in case they are not, they must be properly shimmed using the
spacers to ensure the alignment.
The installation of the awning can occur only when the brackets are perfectly
aligned to the roof of the vehicle.
Important: use of SIKA 252 adhesive is essential for fi xing the bracket
(brackets)
Safety instructions
Before tightening the screws, make sure that the awning position doesn’t prevent the opening of the rear door.
When using the awning please follow the instructions of the product.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed.
Checking that the wall/roof/rear door is sufficiently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce it these
points.
Warranty
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifications and models or to cease production of any model.