AUDIX VX5 Professional Wireless Microphone Instructions
- June 5, 2024
- AUDIX
Table of Contents
VX5 Professional Wireless Microphone
Instruction Manual
User Notice
Dear customers, thank you for purchasing our products! Please read this
instruction manual carefully before using this product, and follow the
instructions to use this product correctly. Please keep this manual for future
reference.
MICROFONO
- MIC set: singing to a here, speech.
- Power switch: push up to open, push down to of.
- Battery cover: Open the bottom cover and place the no.5 battery.
- Damping ring: when the MIC drops it, can protect the MIC to reduce damage.
RECEPTOR
| 1. OUT | 4. GND |
|---|---|
| 2. KC | 5. ANT |
3. VC(3.7V)
Receiver board function
The antenna is permanently connected to the negative stage of the battery;
Make sure the product is in normal use. If the transmitting antenna is
deformed or damaged, please stop using it immediately and return it to the
manufacturer for repair.
The antenna is a permanent connection to the negative stage of the battery;
Make sure the product is in normal use. If the transmitting antenna is
deformed or damaged, please stop using it immediately and return it to the
manufacturer for repair.
SPECIFICATIONS
| Carrier frequency: | 202.2MHz |
|---|---|
| Frequency steadying: | Less than0.002% |
| Modulation mode: | FM |
| Frequency responses: | 20Hz-2KHz |
| microphone sensitivity: | -72dB |
| S/N ratio: | over 70dB |
| Charging voltage: | 3.7V |
| Effective distance: | 20m |
ATTENTIONS
- Do not throw the product into the water or fire.
- Do not use an anti-interference site of the hospital, near the airport, etc.
- please do not disassemble the product, otherwise, you will lose the right to warranty.
PRODUCT WARRANTY
Subscriber data
Address name__
Contact number
Customer address__
Product mode__
Product mode__
Date of buying the machine__
Sales office__
Contact number
Sales office address_
Sales office address___
Postcode————————————
Seal:———————————–
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur In a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver Is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>