AUDIX CabGrabber XL Tension Fit Microphone Holder User Manual
- June 17, 2024
- AUDIX
Table of Contents
CABGRABBER ™ XL TENSION-FIT MICROPHONE HOLDER FOR LARGER AMPS AND CABINETS
OVERVIEW
A great companion to the Audix i5 dynamic instrument mic, the Audix
CabGrabber™ tension-fit mic holder clamps to the top or sides of amps and
cabinets, ensuring secure and precise positioning. Lightweight and compact, it
fits cabinets 14 to 20 inches in depth (the standard CabGrabber fits 8- to
14-inch amps and cabinets). Strong enough to hold microphones up to one pound,
the CabGrabber XL is compatible with every standard mic clip and works equally
well on cabinets with a flat surface or a recessed edge. Its tubular arm can
rotate 180 degrees, allowing the microphone to be positioned directly over the
sweet spot.
USER TIPS (MICROPHONE POSITION)
Edge mounting — The most popular position is just inside the edge of one of
the speakers, within one inch of the grille cloth, with the mic axis
perpendicular to the amp face. This position softens the tone somewhat. For
more tone variation, angle the mic slightly off axis (but not too much or you
will lose the intensity of the pickup).
Toward the center — The center of the speaker produces a harsh sound and is
typically not a desirable location for the microphone. However, as you move
towards the center of the speaker from the edge, the tone takes on more
“bite”. Move the mic from the edge towards the center to find the sweet spot.
Large diaphragm microphone — In addition to holding a dynamic mic like the i5,
the CabGrabber is capable of holding a large diaphragm condenser like the
Audix CX112, offering another option for creating a signature sound.
INSTALLATION
- Grip the neck and rear of the CabGrabber.
- Place the rear grip into position on the back of the cabinet first. Then pull the front grip out and slide it over the front of the cabinet. Adjust so that the bar is in a level position.
- Adjust the neck choke to the desired position and hand-tighten the locking nut.
- Adjust the axis of the microphone into its final position.
DIMENSIONS
FEATURES
- Precise microphone positioning
- Simple, elegant, compact and easy to use
- No tools required
- Adjustable from 14 to 20 inches
- Mic arm hand tightens firmly into position
- Holds mics weighing up to 1 pound (.45 Kilos)
- Works on cabinets with flat or recessed edge
- Clamps to side or top of cabinet
- Durable steel construction
MODEL VARIATIONS
- CABGRAB1 – Fits 8- to 14-inch cabinets
- CABGRABXL – Fits 14- to 20-inch cabinets
SUPPLIED ACCESSORIES
- DCLIP – Heavy-duty snap-on clip for ADX51,SCX Series, others
OPTIONAL ACCESSORIES
- MC112B – Hard-mount clip for CX112B and CX212B large diaphragm microphones
IMPORTANT: Audix is not responsible for any damage caused to amplifiers, speakers, or cabinets as a result of using this product. When used properly, this product is safe to use and will not harm most cabinet coverings and finishes. Extra care should be taken with vintage and collectible amplifiers, cabinets, and speakers to reduce the potential for blemishes, dents, or nicks in the covering or finishes.
© 2019 Audix Corporation. Audix is a registered trademark of the Audix
corporation.
Specifications subject to change without notice.
For service and warranty information, visit
AudixUSA.com/service
CabGrabber XL Spec Sheet v2.0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>