SHOCKFLO PIO1 200W Car Power Inverter User Manual

SHOCKFLO PIO1 200W Car Power Inverter

INTRODUCTION

Thank you for purchasing Shockflo 200W Power Inverter.
The product is only applicable to cars with a 12V battery and can output a 110V AC power supply. For your and others’ safety, please carefully read this User Manual before using the inverter and abide by our recommendations to operate the inverter.
If you encounter any questions or difficulties while using.
please contact our customer service promptly via Email at support@shockfloauto.com

ACCESSORIES LIST

SPECIFICATION

FUNCTIONS

1.  The default fuse in the cigarette lighter plug supports 15A. The total output for AC sockets shouldn’t be more than 180w.

2. The switch button can only control the AC sockets.
   While the switch is on, the AC sockets supply power normally. Otherwise, the AC sockets don’t supply power.

3. The PD, QC and USB 2.4 supply power when the inverter is plugged, no matter the status of the switch is ON or OFF.

4. The PD and QC ports could support Fast Charging, but fast charging won’t work when both ports are used.

5. The LED battery voltage indicator is used to display the real-time voltage of the car battery.

6. The functions of the LEDs are shown as follows:

TABLE 1

INSTRUCTIONS

1. Please choose the fuse of the inverter based on the maximum current value of the car cigarette lighter socket. The inverter could be equipped with fuses of 12A, 15A, and 20A. The default fuse installed is 15A.
2. If you need to turn on the power of the AC socket, please hold the switch for 2s before plugging the load device. Hold another 2s of the switch if you want to turn off the power.
3. When the inverter is plugged into the cigarette lighter socket again, the switch would be in the OFF status, and the AC sockets have no output.
4. Both the PD port and QC port support fast charging For a better user experience, please use the official or authorized original charging cables.

FUSE REPLACEMENT PROCEDURES

• step 1
  Check your cigarette lighter fuse amp on Current Täble

• Step2:
  Seléct Fuse with closest Currents supported as in the Current Table

• Step3:
  Take off cigarette lighter plug cover couñterclockwise

• Step4:
  Remove the cover

• Step 5:
  Take out the fuse and replace it with another fuse.

• Step 6:
  Put the cOver back to the cigarette lighter plug

• Step 7:
  Activate the engine and insert the inverter into the cigarette lighter SOcket.

NOTE

• If the Fuse burned, please troubleshoot before replacing it with a matching fuse.
• Fuses can also be purchased at a local store.
• Do not use metal needles as fuse. To avoid the danger of overheating or catching fire, don’t use a fuse of overlarge capacitance.

WARNING

1. The inverter is only applicable to cars with DC 12V batteries. Using the inverter with high voltage battery may cause damage to the inverter.
2. Unplug the inverter from the cigarette lighter socket or turn off the switch of the inverter before starting the engine, otherwise, the load device may be damaged.
3. The total power of the load devices that are connected to the inverter cannot exceed the rated current of the cigarette lighter socket, otherwise, the fuse may be blown.
4. Danger! High Voltage Alert! Do not disassemble the inverter and keep it away from children.

NOTICE

1. If you will not use the inverter for a long time, please remove it from the cigarette lighter socket to prevent the battery power drained.
2. The inverter comes with an intelligent cooling fan. When the internal temperature is greater than 30°C, the fan will start to rotate, and when the internal temperature is less than 30°c, the fan stops.
3. When using the inverter for a long time, it is recommended to keep the total power within 140oW to achieve the best performance of the inverter.
4. When using the inverter, it is not recommended to place the inverter on the center console to prevent the inverter from sliding down and causing damage;
5. The inverter will generate heat during normal operation, so avoid placing the inverter under direct sunlight or near heat-sensitive materials;
6. For better performance of heat dissipation, it is suggested to keep the inverter away from other objects at least 2 inches (5Imm)
7. Some phone chargers with rated power greater than 65W have a built-in PFC circuit, which may cause the inverter to trigger the protection function, but it will not damage the inverter.
8. Do not expose the Inverter to water, rain, snow or spray.
9. When the output of the voltmeter of the inverter is too low, it is necessary to use a true RMS multimeter to test to obtain accurate measurement results

TROUBLESHOOTING

EMAIL AND WEBSITE FOR SUPPORT
If you have any questions about it, please feel free to get in touch with us. Your valuable opinions and suggestions are highly appreciated
EMAIL: Support@shockfloauto.com
Address: www.shockflo.com

WARRANTY
We provide high-quality assurance services with a warranty of 18 months.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>