KID TRax VKS-002 XD Realtree Whipsaw UTV Ride On Instruction Manual

June 5, 2024
KID TRax

KID TRax - logo

Instruction Manual

Fused tube:

WARNING
In case of overloading or improper use of the vehicle, the fuse will be cut automatically for 10-20 seconds. And then will be connected to the power automatically. To avoid the fuse cutting the power, note the following:

  1. The maximum weight of the toy car must be limited to 110 Lbs.
  2. Do not tow anything behind the vehicle
  3. Avoid all kinds of liquid immersion which may cause a short circuit.
  4. Don’t revise the motorcycle’s circuit or the structure.

CHARGING:

WARNING: For the purpose of recharging the battery, only use the charger provided with this toy.

  1. Like the below picture, insert the charger plug into the charging hole under the vehicle seat.
  2. Like the picture, insert the power plug into the matched stable AC power. Attention when charging:KID TRax VKS 002 XD Realtree Whipsaw UTV Ride On - Fig

Attention when charging:

  1. Adults should do the battery charging,
  2. For the first use when the battery is fully charged, charge for another 4-6 hours.
  3. Charge the battery if the vehicle runs slower, and can charge for up to 8-12 hours. But cannot charge over 12 hours.
  4. Cannot open or decompose the battery and charger, should use the matched charger and battery.
  5. When charging, do not tum the battery upside down.
  6. Before charging, check if the charger, battery, and plug are fine. If it’s broken, do not use it. If it’s repaired, use then
  7. Charge the battery fully. If you will store the battery for a long time, then charge it every 3 months, in this way you can extend the lifetime of the battery.

Care and maintenance:

  1. Adults should check regularly (once every two weeks suggested), wires, plugs, electrical, housing, steering systems, and the UTV speed. If there is any problem, then stop the use until it’s fully restored
  2. In order to clean vehicles, please use a soft, dry cloth to wipe. You can not use water for cleaning, since this will lead to corrosion in the switch and cause switch failure.
  3. This product cannot be stored in high-temperature places or near a fire. The product should be covered on snowy and rainy days.
  4. Charge the battery fully if you will store it for a long time, then charge it every 3 months. In this way, you can extend the lifetime of the battery.
  5. If you stop using the car, take off the battery, turn off the power switch and disconnect the battery connection
  6. Do not revise the toy car’s circuit and structure. The key parts should be maintained and guided by the professional staff.
  7. Don’t recharge the non-rechargeable batteries, do not mix the old and new or different types of batteries. Pay attention to the Positive and negative.
  8. Recharge the battery after each use. Only an adult can handle the battery. Recharge the battery at least once a month when the vehicle Raider is not used

Trouble Shoot:

The vehicle does not move

  1. Check whether the positive and negative wires of the power supply are firmly plugged in.
  2. Check whether the power switch is on.
  3. The fuse is blown or tripped.
  4. Check whether the charger is inserted into the charging hole. If yes, then The toy car will automatically cut off the power supply. After unplugging the charger, it can be used.
  5. The foot switch or manual button is stuck below and cannot be pressed?
  6. Check whether the wheel is stuck with debris

Slow vehicle movement:

  1. Whether the battery is sufficient. If so, it shall be charged in time.
  2. Check whether there is debris stuck on the wheel.
  3. Whether the vehicle is overloaded.
  4. No matter whether the charger is damaged or not, the battery cannot be charged.

The battery cannot be fully charged:

  1. Check whether the charger is normal. When the charger is burnt, the charger will heat up. Do not worry this is normal
  2. Check whether the battery is normal.
  3. Check whether the charger or battery connection is loose.

WARNING:
Use caution as misusing or mishandling the battery may cause a FIRE or EXPLOSION which may result in personal injury, property damage, or death. The user must have an appropriate understanding of the potential dangers of NON- SPILLABLE LEAD ACID ION BATTERIES before purchase and usage. No express or implied guarantee of compatibility, or suitability fitness for any particular purpose or device can be made. This battery is manufactured and sold for the intended use of system integrations with proper protection circuitry or battery packs with a BMS (battery management system) or PCB (circuit board/module). This battery is neither designed nor intended to be used with an E-CIGARETTE, VAPORIZER, or similar device and MUST NOT be used with such devices due to RISK OF FIRE or EXPLOSION. If purchasing this battery for resale purposes, you MUST forward ALL warnings to all customers for their reference and safety!

  • DO NOT USE WITH E-CIGARETTES, VAPORIZERS, OR SIMILAR DEVICES
  • DO NOT STORE BATTERY LOSS OR IN A POCKET, PURSE, ETC. ALWAYS USE A PROTECTIVE CASE OR BOX FOR STORAGE AND TRANSPORT
  • WHEN NOT IN USE, ALWAYS STORE NON-SPILLABLE LEAD-ACID ION BATTERIES IN THE PROTECTIVE CASE/BOX.
  • Misusing or mishandling Non-Spillablelead acid ion batteries can pose a SERIOUS RISK of PERSONAL INJURY and PROPERTY DAMAGE.
  • BATTERIES MAY EXPLODE, BURN, OR CAUSE A FIRE IF MISUSED OR MISHANDLED
  • Usage of batteries is AT YOUR OWN RISK!
  • ONLY use with proper protection circuitry
  • DO NOT short circuit intentionally or unintentionally.
  • KEEP AWAY from metal/conductive object10 prevent short-circuiting.
  • DO NOT use if the battery is damaged in any way.
  • DO NOT over-charge or charge above the maximum voltage rating.
  • DO NOT over-discharge or exceed the continuous discharge rating.
  • DO NOT modify, disassemble, puncture, cut, crush, or incinerate.
  • DO NOT expose to liquids or high temperatures.
  • DO NOT solder onto battery, spot weld only.
  • DO NOT use force to install or install in reverse/backward.
  • ONLY use within manufacturer’s specification
  • KEEP AWAY from pets and children.
  • ALWAYS charge in or on a fire-proof surface and never leave batteries charging unattended.
  • ONLY use a smart charger designed for this specific type of battery.
  • DO NOT mix and match brands and models, old and new, used and unused batteries.
  • STOP immediately if while charging/storing/using the battery it emits an unusual smell, feels hot, changes color or shape, or appears abnormal in any way.
  • It is your responsibility to determine that your charger or device is functioning properly.
  • If exposed to battery electrolyte, flush with water immediately and/or immediately contact a physician or emergency services.
  • DO NOT throw away in trash; contact your local jurisdiction for proper recycling or disposal.
  • Resellers MUST forward ALL warnings to all customers for their reference and safety.

BATTERY DISPOSAL:

Battery Recycling-recycling Ride-on battery

Ride-on toys, electric bikes, and electric scooters – we all have them and we all will have to replace our batteries at some point, or perhaps already have.
What to do with those used electric kids’ car batteries?
You are not allowed to put them out with the trash and can’t just toss them in the river or bury them in the backyard because it is devastating to the environment and the public health, not to mention illegal according to Federal law (40 CFR part 273). Most states have their own laws prohibiting the disposal of rechargeable batteries, as well. So, the big question – what to do with the old batteries?
The answer: recycle them!
You can take your used rechargeable batteries to one of your local Department of Sanitation’s Household Special Waste Drop-off Sites. They offer battery recycling information for Nickel Cadmium (Ni-Cd), Nickel Metal Hydride (Ni- MH), Lithium-Ion (Li-ion), or Small Sealed Lead (Pb) weighing 2 pounds or less.
Since most of us use lead batteries weighing much more than 2 pounds, check out your own city’s Department of Sanitation web page and see what they have to offer – or else just call them. Another option is retail stores, like auto parts stores or service outlets, which sell new Sealed Lead Acid batteries. Most will likely accept a small number (one or two) of spent Sealed Lead Acid batteries for recycling.
Tip: When transporting batteries be sure to eliminate the terminal contacts by either placing the battery in a plastic bag or wrapping black electrical tape around them

Table 1
Remote control instructions

KID TRax VKS 002 XD Realtree Whipsaw UTV Ride On -
Fig2

|
---|---
1. Remove the small screw from the battery compartment cover. 2. Lift the battery cover off the remote control.
3. Insert two AAA-size batteries Into the battery compartment as shown. Note: Batteries NOT included.
4. Replace the battery compartment cover and fasten it with the small screw you removed In step one.| 1. The speed indicators will flash 3 times when the batteries are installed.
2. Press the Car Select indicator for approximately 2 seconds. The Car Select indicator will flash. 43
3. Press the On/Off switch on the car immediately. If the Car Select indicator is not illuminated, repeat step 2.

WARNING

  • DO NOT mix old and new batteries.
  • DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
  • Non-rechargeable batteries are not to be recharged. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply terminals are not to be short-circuited. Rechargeable batteries are only to be charged under adult supervision.
  • Rechargeable batteries are to be removed from the toy before being charged.

Please contact Best Ride on Cars before returning this product to the retailer!!!
If you find that you have any trouble with assembly, missing or damaged parts, please contact us at:
Toll-Free: 1-800-671-9786
Ph: 469-209-8741 Or via EMAIL at:
[email protected]

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals