nulaxy M500 Bluetooth Mouse User Manual

nulaxy M500 Bluetooth Mouse

Instructions

First Use

1. Put an AA dry cell into a mouse with the correct polarity direction, and turn power button on
2. The mouse default is 2.4G mode, the mouse mode indicator light will flash green light three times at 0.5Hz/s the indicator light will flash, then plug the USB receiver in the computer port, then the indicator will stay on for 2 seconds then go out, the mouse is paired with the computer automatically, then the mouse is workable.
3. Short press the code button, the mouse will enter into Bluetooth mode, then long-press the code button for about 3 seconds to enter into pairing mode, the mouse mode indicator light will flash blue light at 1HZ/ second, then turn on Bluetooth on the device you want to connect, select’BT3.0 Mouse” or “BT5.0 Mouse” and connect.

Switch Between 2.4G Wireless Mode and Bluetooth Mode

1. Once in 2.4G Wireless Mode, short press the code button, the mouse will enter into Bluetooth mode, then long-press code button for about 3 seconds to enter into pairing mode, the indication light will flash blue light, then turn on Bluetooth on the device, select’ BT3.0 Mouse” or “BT5.0 Mouse” and connect.
2. Once in Bluetooth mode, short press the code button, the mouse will enter in to 2.4G wireless paring mode, the mouse mode indicator light will flash green light three times at 0.5Hz/s, then plug the USB receiver in the computer port, then the indicator will stay on for 2 seconds then go out, the mouse is paired with the computer automatically

Solutions for 2.4G Connecting Problems

1. Repeat the pairing steps after confirming that the mouse is under in 2.4G mode. Press left button right button and scroll wheel simultaneously for 3 seconds, and release them after the indicator light flashes quickly. Then plug USB receiver in computer port for pairing.

Feature

1. Left Button
2. Scroll Wheel
3. Right Button
4. Power Button
5. Code Button
6. USB Receiver
   (Stored in the battery compartment)

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>