Softbank Robotics P0004930100T soft bank robotics User Manual
- June 5, 2024
- Softbank Robotics
Table of Contents
User Manual
Softbank Robotics corp.
Product Name: Notification Pager Transmitter
Model: P0004930100T
FCC ID: 2ATI9- P0004930100T
IC ID 25110- P0004930100
SAFETY PRECAUTIONS
Please read the safety precautions carefully to ensure the correct use.
Do not disassemble, modify or repair the device or the battery by yourself,
otherwise, the warranty will be invalid.
Do not crush, throw, or puncture your device. Avoid dropping, squeezing, or
bending your device.
Do not use your device in a moist environment.
The operating temperature should be +5℃ —+35℃.
Do not expose your device to areas with flammables and explosives.
Do not tum on your device when it is prohibited to use.
For driving safety, the driver cannot operate the device when the car is in
motion.
Use a dry soft cloth to clean the device; do not use water, alcohol,
detergent, or any chemicals.
Keep the device battery and charger out of the reach of children to prevent
them from swallowing it or injuring themselves by accident. Children should
only use the device with adult supervision.
Observe all rules and regulations applicable to mobile products in hospitals
and health care facilities.
Only use the battery included with the product.
A minimum separation of 50mm distance must be maintained between the user’s
body and the device, including the antenna during body-worn operation, to
comply with RF exposure requirements.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
“Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment”
“This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.”
ISED Compliance
“This device complies with Industry Canada’s license-exempt RSS. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>