ALLOY AHH3ZW Z-Wave and Data Processor Component of Smart Home Hub User Guide

Smarthome

Getting Started

The Alloy SmartHome Hub works best if installed in a central location to where your smart devices will be connected. Maintain a minimum separation distance of 7.6 inches (20 cm) between this equipment and any person or other devices. To install:

1. Mount a 5.5-inch (14 cm) DIN rail to a wall in the desired location and slide the hub onto it.
2. Connect the supplied power adapter.
3. When the status LED turns solid green, the hub is available for use.

Important Safety Instructions

• Read, follow, and keep these instructions.
• Heed all warnings.
• Do not use this product near water or expose the product to dripping or splashing of any water or liquid.
• Clean only with a dry cloth.
• Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
• Only use attachments and accessories specified by the manufacturer.

Certifications

Model: AH-HUB3
Certified under FCC Part 15
FCC ID: 2AXMUAHH3ZW

Information To The User

Changes or modifications not expressly approved by SmartRent could void your authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and  used as instructed by SmartRent, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for help.

FCC Statement

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation.

Tested to Comply With FCC Standards
FOR HOME OR OFFICE USE

For More Information

https://www.smartrent.com/compliance
Please visit
smartrent.com/compliance
SmartRent.com, LLC (SmartRent)
18835 N Thompson Peak Pkwy, Suite 300
Scottsdale, AZ 85255

Documents / Resources

| ALLOY AHH3ZW Z-Wave and Data Processor Component of Smart Home Hub [pdf] User Guide
AHH3ZW, 2AXMUAHH3ZW, AHH3ZW Z-Wave and Data Processor Component of Smart Home Hub, AHH3ZW, Z-Wave and Data Processor Component of Smart Home Hub
---|---

References

• Smart Home Solutions | SmartRent: Opening Doors to a Smarter World
• Compliance | Alloy SmartHome Hub Model AH-HUB3

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>