SIFENE 278 Centrifugal Juicer Instruction Manual

: June 15, 2024
: SiFENE

Table of Contents

SIFENE 278 Centrifugal Juicer
Product Information
Product Usage Instructions
Construction diagram
Instructions
Cleaning and Maintenance
Possible error messages
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SIFENE 278 Centrifugal Juicer

SIFENE-278-Centrifugal-Juicer-PRODUCT

Product Information

Specifications:

Model: Centrifugal Juicer
Brand: Sifene
Rated Voltage: 120V
Frequency: 60Hz

Product Usage Instructions

Safety Precautions

Read the manual carefully before use.
Ensure the juicer is compatible with the rated voltage (120V, 60Hz).
Do not allow children to play with the device.
Handle sharp cutting blades, emptying the bowl, and cleaning with caution to avoid injury.
Keep the juicer and its cord out of reach of children.
If the power cord is damaged, contact the manufacturer or qualified personnel for replacement.
Always disconnect the appliance from the power supply when not in use, during assembly/disassembly, and cleaning.

Intended Use

This appliance is intended for use in households, staff kitchen areas, farmhouses, bed & breakfast environments, hotels, motels, and other residential areas.

Preparing for Use

Ensure all detachable parts, such as the juicer strainer and lid, are in place and fully attached before powering on.
If the juicer strainer is damaged, do not use the juicer.
Avoid putting hands or sharp objects into the feed inlet during operation.
Do not use items other than the provided pusher and keep eyes away from the feed inlet to prevent accidents.
Avoid touching parts such as the juicer screen and motor with the operator’s body or hard foreign objects during operation.

Operating and Cleaning

Before removing detachable parts, ensure the motor has stopped running and the power supply is disconnected.
Process fruits and vegetables with pits, hard seeds, thick skin, or hard-to-remove parts separately.
Do not submerge the juicer in water or rinse it directly with water to avoid failure. Disconnect the power supply before wiping the juicer body.
Do not clean the juicer with steel wool, abrasive cleaners, or corrosive liquids.
Follow the rated working time: do not exceed 1 minute of continuous work, allow a 2-minute break after each cycle, and a 15-20 minute break after 3 cycles before restarting to extend the motor’s service life.

Maintenance and Troubleshooting

Non-professionals should not accidentally remove detachable parts to avoid electric shock. If the juicer breaks down, send it to the specified maintenance station for service.
When finished using the juicer, always unplug the power cord. If the power cord is damaged, have it replaced by a professional or authorized maintenance department.

FAQ

Q: Can I use this juicer with a different voltage?
A: No, this juicer is designed for use with a rated voltage of 120V, 60Hz. Using a different voltage may damage the appliance.
Q: Can children use this juicer?
A: No, this appliance is not intended for use by children. Keep it out of their reach and ensure they do not play with it.
Q: How should I clean the juicer?
A: Do not clean the juicer with steel wool, abrasive cleaners, or corrosive liquids. Wipe the juicer body with a damp cloth after disconnecting the power supply.
Q: How long can I use the juicer continuously?
A: The duration of continuous work must not exceed 1 minute. Allow a 2-minute break after each cycle and a 15-20 minute break after 3 cycles to prevent overheating and extend the motor’s service life.

Read the manual carefully before use

before usin g the ju icer, ple ase che ck the corresp ondence between the actual voltage and the rated voltage (120 60Hz).
appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
children must not play with the device
warning: risk of injury due to misuse. Use caution when handling the sharp cutting blades, when emptying the bowl, and during cleaning.
this appliance must not be used by children. Keep the unit and its cord out of the reach of children.
if the power cord is damaged, it must be replaced by the manufacturer, its after-sales service or similarly qualified persons to avoid a hazard.
Always disconnect the appliance from the power supply when it is left unattended and before it is assembled, disassembled or cleaned.
this appliance is intended for use in household and similar applications such as:
Staff kitchen areas in stores, offices and other working environments;
farmhouses;
By customers in hotels, motels and other residential areas;
Bed & Breakfast environments.
before power on, make sure the detachable parts, such as juicer strainer and lid, are in place and fully attached; if the juicer strainer is damaged, please stop using the juicer.
do not put hand or sharp objects into the feed inlet during operation.
It is strictly forbidden to use other things as pusher and bring eyes near the feed inlet in case of accidents.
do not touch parts such as the juicer screen and motorcycle with the operator’s body or other hard foreign objects during operation in case of injury or damage to the juicer.
when you use the juicer and finish the juicing process, make sure that the motor stops running and the power supply is disconnected before removing the detachable parts.
Fruits and vegetables are with pit, hard seeds, thick skin or hard to be removed and then processed.
it is strictly forbidden to sterilize all accessories with hot water above 80 ° C and microwave with thermal deformation and damage.
do not put the juicer directly into water or rinse it with water in case of failure. Before wiping the juicer body, be sure to disconnect the power supply.
do not clean the juicer with steel wool, abrasive cleaners or corrosive liquids.
Please operate it in strict accordance with the rated working time: the duration of continuous work must not exceed 1 min; each cycle must be stopped for 2 minutes after the completion of functions; It must be stopped 15-20 minutes after the continuous operation of 3 cycles, and then restarted after the motor cooling. This method is helpful to extend its service life.
non-professionals must not remove its detachable parts accidentally, as it may cause electric shock. If the juicer breaks down, please send it to the specified maintenance station for service.
When finished, unplug the power cord. If the power cord is damaged, it must be replaced by the professional, his maintenance department or similar department to avoid danger.
This juicer is intended for household use only. It is not advisable to use it for commercial purposes.
for contact with food

Construction diagram

$SIFENE-278-Centrifugal-Juicer-FIG- $1$$

Pusher: To improve the efficiency of juicing, gently push the ingredients in to ensure full contact with the juicer screen when you put the ingredients in.
lid: As the main component of juicing and to protect the safety, the lid is connected to the body.
juicer sieve: cut the ingredients to the bottom with the cutter, filter the juice and separate the pomace with the side sieve.
middle ring: separate juice through juicer sieve and discard.
spout: fruit juice comes out through the center ring.
motorcycle: used to connect the juicer strainer to make the strainer self-centering for easy pick up and placement.
lid: Filter fruit juice bubble and protect from dust.
juice container: get and collect fruit juice separated by juicer sieve.main body: main part of juicer with internal motor and other parts.
main body: main part of juicer with internal motor and other parts.
clamp: control connection between the upper cap and the body.
Rotary switch: control the working status of juicer: pulse (P), stop (0), slow gear (1) and fast gear (2).
Mains cable: Connect the power source (120V ~ 6 0 Hz).
Pomace cup: Get and collect pomace separated by juicer.
Safety switch (micro switch): Protect the operation when you connect the juicer to the power source.

Instructions

Before using the juicer for the first time, please thoroughly clean the parts that come in contact with the ingredients.

Knob overview

Position “P”: fast and momentary rotation
Position “0”: Closed and off
Position “1”: Low-speed stage, applied to process soft fruits and vegetables, such as: Watermelon, tomato, cucumber, strawberry.
Position “2”: High-speed stage, applied to the processing of all fruits and – vegetables.
See “Fruit selection tips” for detailed instructions on fruit and vegetable selection and position typing.

Application method

The juicer is equipped with double safety system and cannot work until all parts are installed correctly.
Please install and use the juicer as follows:

Set the body switch to “0” position, and put the middle ring into the body according to Fig.1.
put the juicing screen into the center ring according to Fig.2 and make sure the juicing screen is installed correctly on the motorcycle (check the completeness of the juicing screen before use. Do not use if damaged).
Insert the upper cap from the top right into the body according to Fig.3 and install it in the direction indicated on the upper cap. 4. $SIFENE-278-Centrifugal-Juicer-FIG- $2$.$
place and press the clamp on two lugs on the upper cap. It is correct when you hear click, or the juicer will not work.
Tilt slightly and place the pulp cup under the center ring outlet;
Press the bottom of the pulp cup onto the body to install it.
place the juice cup under the juice outlet. $SIFENE-278-Centrifugal-Juicer-FIG- $3$$
Connect the power source and prepare it for (Make sure the switch is off before connecting). $SIFENE-278-Centrifugal-Juicer-FIG- $4$$
clean, peel and cut fruits and vegetables into pieces, then cut into pieces and granules of suitable size for the feed inlet.
start the switch and select a suitable tap position according to the type of fruit (see tips for selecting fruits). To prolong the life of the juicer it is advisable to run it continuously within 1 minute.continuously within 1 minute.
Place cut fruits and vegetables into the feed inlet of the top cap and gently push on them with the pusher. Do not press the fruits and vegetables onto the pusher with too much pressure, as this will affect the quality of the final result. If the pomace outlet is clogged or the pomace cup and juice pot are full after a period of time, disconnect the power source and clean it before use. Do not insert fingers or other objects into the feed inlet!
when ingredient processing is completed, when no more juice comes out of juicer, turn off the juicer and disconnect the power source. Then wait until the motor and juicing screen stop rotating before removing the Juice Cup from the Juice Outlet. (Fresh fruit juice should be drunk immediately as its taste and nutritional value will be affected if exposed to air for a while). $SIFENE-278-Centrifugal-Juicer-FIG- $6$$

Tips for fruit selection

Use fresh fruits and vegetables as they contain more liquid. Specific preferred fruits are: Pineapple, beet, celery stick, apple, cucumber, carrot, spinach, melon, tomato, tangerine, grape, etc.
it is not necessary to remove thin peels and skins. Only thick skins (e.g. oranges, pineapple or beet) need to be removed. Seeds (e.g., oranges) are also removed.
When removing apples, fruit density depends on the variety of apple selected. For apple with more liquid, fruit will be denser. So you can choose apple variety according to your fruit density requirements.
Since fresh apple juice will turn brown quickly, you can add a few drops of lemon juice to slow down this color change process.
leaves and stems (such as lettuce) could be extracted in the juicer for juice.
It is not advisable to put fruits that contain starch, such as bananas, papayas, avocados, figs, and mangoes, into the juicer for juice extraction.

Cleaning and Maintenance

Put this juicer in a dry and well-ventilated place where it can be stored for a long time so that the motor will not come into contact with moisture, which may endanger the safety of the appliance.
It is easy and convenient to clean the juicer immediately after use. It is strictly forbidden to put the body directly into water or rinse with water.
The power supply must be disconnected before wiping the body with a dry cloth. Parts other than the body can be washed in water.
Do not wash the detachable parts with water hotter than 60 ° C or sterilize them in a high-temperature disinfection cabinet. It is correct to put the cleaner in warm water and clean it with a cleaning brush, then rinse it with clean water.
Clean the detachable parts according to the following steps:
Take out pulp cup;
Take down pusher
Remove clamps from both sides outward to open top cap. $SIFENE-278-Centrifugal-Juicer-FIG- $8$$
Remove the Top Cap, the Juice Strainer and the Center ring one at a time.
Note : When cleaning the juicer strainer, add a cleaner to the water. Clean the juicing strainer with a cleaning brush and then rinse it with clean water. other parts are cleaned directly by rinsing.
Method of juicing sieve:
grasp the blade with both hands and lift it up to remove the lift it up to remove the juicing sieve. 2.
Grasp both sides of the center ring with both hands and lift up quickly (not too hard) to pull out the juicing screen along with the center ring.

Possible error messages

Typical Failure| Root Cause Analysis Solution| Possible Solution
---|---|---
The juicer does not work after switching on|

Center Ring was not installed;
Top Cap was not installed;
Broken microswitch

|

Put the middle ring in place;
Put the top cap on;
Replace the top cap;
Put all the parts in place and Job.

The engine gives off a disguised odor during the first few hours of use| Normal phenomenon| If the odor persists after repeated use, please send it to the specified maintenance station.
Stop during operation|

The voltage is below the level;
Ingredients are excessive;
Use excessive pressure to squeeze the pusher;
If the motor overheats, it will shut down for protection

|

Check that the Voltage is too low.
Unplug the power source and remove unnecessary ingredients;
Press lightly on the Pusher.
Turn it on for 20-30 Minutes before using it again.

Fruit contains a lot of pomace|

Broken juicing sieve;
A lot of marc accumulated in the center ring.

|

Replace the broken one Sieve;
Replace the center ring.

Few fruits come out|

A lot of marc accumulated in the center ring;
Big pressure on the Pusher exercised.

|

Clean the middle ring.
Press lightly on the pusher.

Abnormal vibration or loud noise|

Juicer strainer was not installed in a straight position.
The juicier was not placed smoothly and quietly, or its foot pad came off;
Tension is excessive;
Ingredients are excessive.

|

Put the juicing screen in place;
Set up the juicer gently and evenly or place the footrest on it.
Check if the voltage is too high;
Disconnect the power supply and take out excess ingredients.

Cutter obstructed| The cutter was engulfed or clogged with ingredients.| Disconnect the power supply, take out the ingredients and cut them into smaller ones Pieces.