live love musis LED Wireless Speaker User Guide
- June 3, 2024
- live love musis
Table of Contents
live love musis LED Wireless Speaker
CHARGING THE SPEAKER
- Charge the speaker before using it far the first time.
- Plug in the cable to the micro USB port and charge for 3 hour
PAI RING YOUR SPEAKER
Your speaker will work best if it is within 33 ft. of your smart device. You may experience sound briefl y cutting off if you are out of range or if your wireless connection is weak Make sure Bluetooth is enabled on your smart phone or tablet before starting the pairing process.
- Turn on the speaker by flipping the Power Switch to the “On” position. The speaker will “beep” when it is ready to connect. by
- From your smartphone or tablet, find a list of nearby devices and choose”FB-383IF,
If pairing successfully. The speaker will “beep” again when pairing is complete!
SPECIFICATIONS
- Output Power:3W
- Impedance: 4 Ohms
- Frequency Response: 2402 MHz -2480 MHz
- Play Time: Up to 2 hours
- Standby Time: Up to 30 hours
- Charging Time: 3 hours
- Battery Capacity: 1200 Mah
- Tma: User use ambient temperature
- No power protection device at the input.
- Caution:
- PCB of battery should not be crushed and twisted.
- Cell body should not be blended.
- Do not disassemble and Do not dispose of in fire.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interterence received,
including interterence that may cause undesired operation. Please note that
changes or, modifications not expressly approved by the party responsible for
compliance could void
the user’s authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursugnt to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interterence will not occur in a particular
installation. Ifthis equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
WARNING
- Keep away from water and moisture.
- Keep away from heat sources.
- Do not disassemble.
FCC ID: 2AANZ383IF-2 BT ID: D051448
CAUTION: Use only the battery provided. there may be a risk of explosion
if a wrong type of battery is used for the parent unit. The battery cannot be
subjected to high or low extreme
temperature and low air pressure at high altitude during use, storage or
transportation. Disposal of battery into fire or a hot oven, or mechanically
crushing or cutting or the battery can result in an explosion. Leaving the
battery in an extremely high temperature surrounding environment can reslt in
an explosion or the leakage of flammable liquid of gas. Battery subjected to
extremely low air pressure may result in an explosion or the leakage of
flammable liquid or gas. Dispose of used battery according to the
instructions.
DGL Group Ltd.
2045 Lincoln Highway, 3rd Floor, Edison, NJ 08817, USA.
www.dglusa.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>