TREASURE GARDEN EVO Cordless Umbrella Dual Light Sound Pod User Guide

TREASURE GARDEN EVO Cordless Umbrella Dual Light Sound Pod

Thank you for purchasing Treasure Garden’s EVO Dual-Light Sound Pod. Please remove all contents from the package, inspect and review checklist.

CHECKLIST

Remove protective cap from charging/USB port and connect the power supply to the EVO charging port, then plug the other end into any 110V power source. The EVO is fully charged when the red Bluetooth indicator lights tum off (approximately 3 hours).

Note:
Charge EVO in dry area to keep from damaging. Top unit must be installed on bottom unit correctly to charge. Make sure buttons on top unit and bottom unit align prior to connection power supply.
We recommend fully charging EvO before you store for extended periods of time.

STEP PAIRING BLUETOOTH DEVICE

• To tum on Bluetooth, locate the Bluetooth power button on the top unit of the EVO.
• Press and hold Bluetooth power button for 3 seconds until you hear a prompt sound.
• The Bluetooth indicator light will blink white when in pairing mode.
• From your music device, tum on Bluetooth and switch your device to discovery mode.
• Select “EVo” from your device options. You will hear a set tone and the Bluetooth light will become solid white once the EVO and your music device are paired successfully.
• To turn on bass speaker, locate the Bluetooth power button on bottom unit.
• Press and hold Bluetooth power button for 3 seconds until you hear a prompt sound.
• The Bluetooth indicator light will blink white first, followed by a set tone, and then become solid white. Your music device and EVO top and bottom unit are now paired successfully.
• Use controls on music device to select songs from playlists and adjust volume.

NOTE
Sound quality will lessen or music will stop playing when music device is approximately 30 feet away from EVO

STEP UNPAIRING BLUETOOTH DEVICE

Only 1 music device can be connected at a time.
To pair another device, first unpair the current device by disconnecting Bluetooth on the device, or pressing and holding the Bluetooth power button on top unit for 2 seconds.
You will hear a tone when the curent music device unpairs and the Bluetooth light will begin blinking white again.

Note:
lf you press the Bluetooth power button once, the music device will pause. Press once again and music will resume.
If you hold the Bluetooth pOwer button for 4 seconds, the device will shut off.

STEP4TURNING DEVICE OFF

To turn off EVO, press and hold Bluetooth power button on top unit for 4 seconds. You will hear a descending tone and Bluetooth Indicator lights will tum off. Both top and bottom units will be disconnected.
Note:

• EVO will tun off automatically when Bluetooth is in pairing mode, or inactive for more than 15 minutes.
• When your music device is disconnected, you will hear a prompt sound from EVO.

LED LIGHTS
To tum on and tum off LED lights, press the LED light power button located on top and bottom units.

STEP ATTACHING EVO TO UMBRELLA

The top unit of the EVO can be attached to umbrella center poles up to 2″ and cantilever umbrella light adapters.
Open EVO by holding the device fimly with one hand and then press “unlock” button with the other hand to release the clamp lock.
Open up the EVO top unit, remove from Bottom unit, and clasp around the mid pole or light adapter. Snap to close.

Note:
When reattaching top unit to bottom, make sure the buttons on the top and bottom unit align. Note the grooves on top unit only line up one way.
Doing so will cause damage to electrical components.

STEP TABLE LIGHT
With the top unit removed, press down adapter rod until rod locks into place.

STEP USB PORT
To charge electronic devices, remove protective cap from charging/usB port. Insert USB cable into USB port located on back of bottom unit. Reattach protective cap when not in use.

Note:
If using USB port and lights, battery life will reduce to 4 hours.

SAFETY PRECAUTIONS

• Position the EVO in a location that will protect it from direct sunlight and moisture
• Do not overcharge the battery. Unplug the power supply when the indicator light tums off. Over charging may cause the battery to become hot, rupture or ignite. If you see any heat defomation or leakage, propertly dispose of the device.
• If unit is exposed to light moisture, allow unit to air dry for a minimum of 24 hours before reuse.
• Power supply must be used indoors only. It is neither designed nor tested for use outdoors, in recreational vehicles or boats.
• Disconnect power and store EVO indoors during inclement weather (rain, snow). Failure to comply will result in product failure or damage.
• WARNING: The EvO Dual-Light Sound Pod is not waterproof. If the EVO is immersed in water or exposed to heavy rain the unit will be damaged and void the 1 year warranty.
• NOTE: We recommend fully charging EVO before you store for extended periods of time.

Power Supply

• Never use a third party battery or power supply. Doing so may increase risk of fire or explosion.
• Contact your local authorized dealer for a replacement power supply.
• During prolonged use, it is normal for the power supply to be wam to the touch.
• Whenusing power supply, avoid direct sunlight and exposure to moisture.
• To prevent damage to the electrical components, do not use the charging or USB port in inclement weather (rain, snow).

FCC warning

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>