FOX ESS LV2600 Voltage Battery User Guide

LV2600 Voltage Battery

Quick Installation Guide

1 Tools Required

The following tools will be required to install the BMS BOX and the battery.

2. Packing List

For LV2600:

J: To match the different inverters, our accessory packs are differentiated, so please look at the wire markings on the white sleeves before wiring.

J-1

J-2

Note:

1. Use only the parts included with the battery pack to ensure proper installation. If anything is damaged or missing, contact manufacturer or your distributor.
2. Package 1&Package2&Package3 are provide separately, not including in battery package. Please contact your dealer if you do not have it.
3. Select an interface (CAN/RS485) based on the actual inverter interface type.
4. If the definition of the communication port from your inverter to the battery is different from all of the above, please make your own communication cable.

3. Terminals

4. Installation Steps

Step 1
Place the front bracket and back bracket as shown below.

Step 2
Insert the battery module into the bracket from front horizontally, and tighten the four screws on the side.

Step 3
Locate the brackets for the second battery on top of the first pair of the bracket and fasten the connecting button on the side.

Step 4
Insert the battery module into the bracket from front horizontally, and tighten the four screws on the side.

5. Wiring Steps

Wiring confirmation: Check whether the power wiring is tight and whether the positive and negative polarities are correct. Check if the wiring of the parallel network port is correct.
Note:
Max. 6 pieces battery per stack. If more than 6 pieces, there may be a risk of collapse.

Battery modules less than 6 pieces: Please stack in one row. Such as:

Battery modules more than 6 pieces: It is required to install into 2 stacks, we recommended to ensure the number of batteries in each stack is even.

Such as:

Detailed wiring diagram:

Note: The red cable is connected to the “+”, the black cable is connected to the “-“. Connect the power cable starting from the first battery module in parallel with other battery modules. Tighten the screws. The positive and negative connection of the battery cable is shown in below.

Communication cable connection:

Step 1 : Take the main positive cable (two orange plugs), the main negative line (two black plugs) to connect to the inverter.

Step 2 : Then connect the RS485-1 or CAN on the inverter to the RS485-1 or CAN of the first battery module, connect the Link Port1 of the previous battery module to Link Port of the next battery module, leave the last module’ s Link Port1 vacant. Wiring shall be connected in the sequence as shown in below.

Note: ADD

ADD: Please refer to page 15 of the user manual.

Grounding cable: Connect the grounding cable to ensure that all batteries are grounded. Wiring shall be connected in the sequence as shown in below.

6. System Start Up

After pressing the power switch for 1s, all LEDs will be on and flashing, which indicates that the battery is started normally. After pressing the “start” button for 3s, the battery will turn on the discharge function.

Note:

1. After the communication between each battery pack lost for 10s, the battery will stop charging and discharging;
2. After the communication between battery pack and inverter lost for 10 minutes, the battery will stop charging and discharging.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>