Fortyfour Group 2AWVU WRISTLER Wearable speaker User Manual
- June 5, 2024
- Fortyfour Group
Table of Contents
USER MANUAL
The Wrestler Wearable Speaker combines the functionality of a speaker and a
microphone into one compact, portable gadget. With IPX5 water resistance, an
adjustable wristband, and a bag clip, you can wear the Wrestler anywhere, rain
or shine!
WEAR IT.
CLIP IT.
ROCK IT.
PAIRING YOUR DEVICE
Turn on the speaker by holding the power button (Figure 1) down for approximately 2 seconds; you should hear a power-up noise and see an ashing white LED light on the front of the speaker to indicate that the device is on and ready to pair. In the wireless pair settings of your mobile device, connect to the device named “Wrestler”. You will hear a noise and see the white LED light turn solid, ensuring a successful pair. The speaker will automatically turn off if no devices are paired after 15 minutes. To connect to a new device, (while turned off) hold down the power button for 5 seconds until you hear the noise. This tone means it’s scanning for a new device.
TRUE WIRELESS STEREO PAIRING
Turn on the Wrestler, simultaneously holding “+” and “-” on any Wrister for 2
seconds, you should hear a connected noise on the Wrestler and see an ashing
white LED. Connect your devices to the Wrestler to enjoy stereo music now.
POWER OFF YOUR SPEAKER
Hold the power button (Figure 1)) down for approximately 2 seconds until
hearing the power-off noise.
CHARGING
Connect the USB charging cable to a power source and insert the micro USB tip
in the charging port located underneath the port ap. Charge the Wrestler
(approx. 1.5hrs) before use. The LED light will turn red while the speaker is
charging and turn off once fully charged.
FUNCTIONS
- Power ON/OFF/Play/Pause/Call
- Previous Track(Short press) Volume-(Long press)
- Next Track(Short press) Volume+(Long press)
- Micro USB Charge Port
- Speaker
SPECIFICATIONS
- Dimensions: 2.2” x 2.2” x 1”
- Speaker Driver: 3 W
- Playtime: 2 Hours (@ 50% volume)
- Wireless Range: ≥33 ft
- Battery: Lithium-ion 3.7V / 300mAh
- Battery Charge Voltage: 5V / 300mA
- Charging Time: 1.5 Hours
- IPX5 Water-Resistant
- Built-In Microphone
LED INDICATOR
Power on: White LED
Connected: Solid white LED
TWS Connection: Flashing white LED
Low Battery: Slow flashing red LED
Charging: Solid red LED
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. Suppose this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on. In that case, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.