Netvue NI-3231 Orb Pro indoor white User Manual

: June 5, 2024
: netvue

Table of Contents

Netvue NI-3231 Orb Pro indoor white
What’s In The Box
Camera Structure
Read Before Installing
Mount Your Orb Pro
FCC Warning
Netvue Protect Plan
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Netvue NI-3231 Orb Pro indoor white

Netvue-NI-3231-Orb-Pro-indoor-white-
product

What’s In The Box

Netvue-NI-3231-Orb-Pro-indoor-white-
fig-1

Camera Structure

Netvue-NI-3231-Orb-Pro-indoor-white-
fig-2

Read Before Installing

Keep Orb Pro and all accessories out of reach of children and pets.
Orb Pro comes with a power adapter. If you prefer other power adapters, please make sure that they allow a DC5V power supply voltage, and an electric current not less than 1A .
Working temperature: -10°C to 50°C (14°F to 122°F) Working relative humidity: 0-95%
Please do not expose the camera lens to direct sunlight.

Note:

Netvue Orb Pro only works with 2.4GHz Wi-Fi.
Strong lights may interfere with the device’s ability to scan QR codes.
Avoid placing the device behind furniture or near microwaves. Try to keep it within range of your Wi-Fi signal.

Set Up With Netvue App

Download Netvue App from App Store or Google Play. Follow the in-app instruction to complete the entire setup process.

Mount Your Orb Pro

You can choose to install it against the wall, under the ceiling, or directly on the desktop.

Use the provided drilling template to mark the position of holes on your wall. Use a drill bit (15/64″, 6mm) to drill two holes, and then install anchors to hold screws.
Install the Mounting Bracket on your wall with the Screws provided.
Put the bottom of Orb Pro against the mounting bracket in the direction shown above, and then rotate counterclockwise to secure it.
Now you can turn around your Orb Pro horizontally and vertically using Netvue App.

Status Light

Solid Blue

| ****

Online

---|---

Rapidly Flashing Blue

| ****

Wi-Fi Conﬁguration Mode

Solid Red

| ****

Ofﬂine

FCC Warning

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

FCC ID 2AO8RNI-3231 CE RED
This product can be used across EU member states.