ARLEC ATL010US 10 Inch LED Selfie Ring Light User Manual
- June 5, 2024
- ARLEC
Table of Contents
ATL010US 10 Inch LED Selfie Ring Light
User Manual
10″ LED SELFIE RING LIGHT
ATL010US
User Manual
For Photography/Live Streaming/Beauty/Makeup/Nail Salon and other lighting
applications.
Installation:
- Unscrew the adjusting knob at the bottom of the Tripod
- Pull the legs straight down and into position
- Adjust the tripod to the appropriate height and tighten the fixture
- Install Ball Joint
- Connect the ring light and the Ball Joint together
- Install the phone holder
Instructions:
After the installation, connect the USB to the power supply and press the to
light up
can adjust the color temperature. (Cold Light, Nature Light, Warm Light)
can adjust the brightness of the ring light. There are 10 color levels, you
can adjust the light to a comfortable level as you need .
Finally, press the to turn off the power.
Instructions for Bluetooth remote:
- Open the remote and the blue lamp will flicker.
- Open the phone Bluetooth and search new service, and then connect it.
- After matching and connecting, open the phone camera app.
- If it’s iPhone, you can straightly use the remote to control photographs.
- If it’s Android, you can straightly use a remote to control photographs. Or download the camera 360 apps and open the app, then choose the volume key as a shooting button in settings to control the remote.
Attention:
When selecting an adapter, it is recommended to use 5V.2A /2. Please unplug
the power after use. Keep away from the fire.
Specifications:
Power: 15W LED
Bulbs: 120 pcs
Luminance: 6000 lux
Power Supply: USB 5V
USB Cable Length: 195cm/77 Inch
Frequency Range:2402-2480MHz
Dimmable: Yes
Color Temperature: 2800-6500K
CRI: 95+
Ring Light Size Diameter: 26cm /10.24
Inch Aluminum Tripod Length: 162cm/64 Inch
Warnings Reference
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Arlec America LLC
9100 Crockett Drive
Lantana Denton Country
Texas 76226
United States