VBeT X200 UC Headset User Manual
- June 5, 2024
- VBET
Table of Contents
VBeT X200 UC Headset
Overview
Thank you for purchasing this Space Headset. Please double-check the contents
of the packaging to verify that you have received all items. Be sure the
completely read the user guide before using the headset. This headset can be
connected/paired with any device that is Bluetooth wireless technology-
enabled. 
Connecting and using your headset
Microphone boom adjustment
The boom arm can be adjusted as required. For optimum performance, the
microphone should be positioned around 2 cm from your mouth. The boom arm can
be slightly bent to allow you to find the right position. 
The Space Mono Corded Headset can be worn on the left or right side. To change the headphone position from right to left, hold the earpiece with your hand and rotate the microphone arm 180°. You can rotate the microphone arm by a maximum of 270°.
Adjusting the Headband
Place the headset receiver to your ear(s), if using a single ear headset you should set the T-bar above your other ear. Adjust the headband until comfortable, ensuring there is virtually no pressure felt on the ears.
LED Display
Headset red: Busy
Headset green: Free
Connection
Connect your Space headset to a free USB port on your PC. Ensure the headset
has been selected as the standard
audio device in the system control audio settings. If necessary, check your
softphone user manual for additional adjustments. 
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user?s authority to operate the equipment.
Warranty
Consequential and incidental damages, including, without limitation, loss of property, and those arising from breach of any express or implied warranty, are not the responsibility of and, to the e xtent permitted by law, are excluded.