VBeT VT X100 USB Series Call Center USB Headset User Manual

X100 USB Series Call Center USB Headset
User Manual

Headset Components

1. Wideband Speaker
2. Ear Cushion
3. Adjustable Headband
4. T-bar
5. Ultra-noise-cancelling microphone
6. Headset Cable
7. USB housing

New Feature

• Work with any PC&Softphone(Skype For Business), Microsoft
  Lync, Avaya, Cisco system,3CX(USB03/USB04 support hook off/on, USB02 support audio)

Connection

• Connect your VT X100 USB Series Headset to a free USB port on your PC.
• Make sure that the headset has been selected as the standard audio the device in the system controls audio settings.
• Check whether you need to adjust these settings to use a headset by reading the operating instructions for your softphone application.

Headset Components

1. Display for mute microphone
2. Mute microphone
3. Volume control
4. Hook On/Off Key
5. Display for Hook Off
6. Mute Speaker(only for USB02)
7. Display for operation(only for USB02)

Using Your Headset
Connect your VT X100 USB Series Headset to a free USB port on your PC.

Wearing Your Headset

When switching the receiver to another side, rotate the microphone boom over the headband to accommodate the left or right ear.

Place the headset receiver to your ear(s), if using a single-ear headset you should set the T-bar above the other ear. Adjust the headband until it is comfortable, ideally ensuring that there is virtually no pressure felt on the ear(s).

To avoid low or distorted sound, and to provide clear and crisp telephone calls, the microphone should be positioned within 30-40mm of your mouth. The microphone boom arm will move in a variety of directions to ensure the best fit.

Your new headset is supplied with a clothing clip to allow the comfortable fitting of your headset without the cable getting caught or inadvertently pulled. The clothing clip should be fastened at a comfortable level, ensuring that there is sufficient slack on the cable allowing free movement of your head without disturbing the headset position.

Ear Cushion Removal
Using both thumbs, remove the ear cushion by gently prying the airplane away from the groove on the receiver.

Maintenance

The ear cushions can be removed for cleaning or replacement.

Accessories
Replacements & enhancements for the VT Series headsets:

1. Clothing clip
2. Headset hook
3. Leatherette ear cushion

Safety

For your own safety, this product should only be used with CE and RoHS- approved equipment. Using this headset with non-approved equipment can void this product warranty.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to pan 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Xiamen VbeT Electronics Co.,Ltd
URL: http://www.vbet.cn
Mail : vt@vbet.cn
Tel: 0086-592-5778728
Fax: 0086-592-5778708
Add : 5th Floor Keji Building#2,No.32 Huoju
East Road,Huli District Xiamen china

References

• 惟贝特 | 全球专业话务耳麦供应商

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>