Zhengzhou HH-670Y remote control User Manual
- June 5, 2024
- Zhengzhou
Table of Contents
Zhengzhou HH-670Y remote control User Manual
Product Overview
Baby carriage remote control product manual
2.4G wireless transmitter remote control Product Tyztpe: HH-670Y
Product Configuration
- Battery Specification: 1.5V(AAA)*2
- Section Operating Voltage: DC 3V
- Quiescent DC: 0.5uA
- Modulation Mode: GFSK
Product appearance structure
Positive
Lower Flank
Left side
Upper Flank
Back
Battery Cover/Battery Bin
Internal product Structure
anteroposterior end of shell
Circuit board
Battery Spring
Component List
- C1-10UF
- C2-100NF
- C3-20PF
- C4-20PF
- R1-100R
- R2-510R
- Dl-LED
- D2-LED
- D3-LED
- K1-664
- K2-664
- K3-664
- K4-664
- K5-664
- K6-664
- IC1-RF CHIP
- Y1-16MHz
Product Description
-
mount the remote control battery, the remote control first indicator light starts flashing.
-
Tum on the baby carriage power supply, the remote control three all bright, namely the code is successful.
Product button description
- ( )forward key: press and hold forward key car forward moving.
- ( )Back button: press and hold the back button the car is backwards moving.
- ( )left turn key: Hold left turn key car direction turn left.
- ( )Turn right key: press right key car direction turn right.
- ( S )speed control key: speed is divided into low, medium and high gear cycle speed, each press one to swith a gear.
- ( P ) Brake Button: press the brake button and remote control the three LED lights on the flashing together, marking the braking status and press the brake button to release the brake.
Zhengzhou Honghui Electronic Manufacture Co.,Ltd
NO.20,4/F, Building 36, Hongsong Road, Gaoxin District, Zhengzhou
Tit : 0371-67811860
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices has been evaluated to meet general RF exposure requirement， the device can be used in portable exposure condition with restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>