Quick WCS 820 Windlass Control Board User Manual

June 5, 2024
QUICK

Quick WCS 820 Windlass Control Board

Quick WCS 820 Windlass Control
Board PRODUCT

DRAWING OF ASSEMBLY

Quick WCS 820 Windlass Control Board FIG
1

Proceed with installation following the numbering of the elements.

  1. Shunting switch

  2. Plastic washer

  3. Anti-rotation washer

  4. Neoprene gasket

  5. Control plate

  6. 4 self-tapping screws

  7. WCS 820 label

  8. Black shunting switch protective capQuick WCS 820 Windlass Control Board FIG 3

    • 7c
      Remove the transparent protective film. Retirez le film protecteur transparent. Retire la película protectora transparente. Die transparente Schutzfolie entfernen.

    • 7a) Remove the protective paper from the back of the label.
      For a better seal, avoid touching the adhesive part with your fingers. Clean the surface of the control plate (5) before applying.
      WARNING : it is recommended not to apply the adhesive on the control plate (5) at temperatures below 18° C.

    • 7b) To apply the label properly, we recommend placing one side against the edge of the control plate (5) first and then completing the application. Press the entire surface firmly to make it stick well.

Installation and use of manual
WINDLASS CONTROL BOARD (UP/DOWN)
Electric device enabling windlass operation even in the rudder area.

DIMENSION

WIRING DIAGRAM

Quick WCS 820 Windlass Control Board FIG
4

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals