Xiamen Goofoo Technology Cube Mini 3D Printer for Kids User Manual
- June 5, 2024
- Xiamen Goofoo Technology
Table of Contents
Goofoo Technology Cube Mini 3D Printer for Kids
User Manual
Cube Mini 3D Printer for Kids
| 
---|---
|
Caution high-
temperature don touch
APP
-
Download mobile App_”CUBE software from Google Play or App Store.
-
Plug in and turn on the printer Touch the power button and the indicator light will turn green.
Attention
1. The printer only supports the 2.461-1z WM network.
2. If there is a change on the Wifi network, like in a different place or with a different Willi router, it is a must to re-configure The printer:–Press the power button and hold for 5 seconds. The Green LED will not go oft indicating the printer enters the factory default settings, and follow the 3rd and 4th steps to re-setup the WiFi network
-
Realize the mobile control of the printer by connecting to the printer hotspot: triter “Setting”–“WLAN” and select the printer hotspot “CUBtwifixxxx”
-
Connect the printer to your network
4.1.Open the App and follow the indication screen to finish the network connecting.
- Print bed leveling The print bed is well leveled when out of the factory, but there will be a deviation during the transportation. If the print results aren’t good, we can do the small calibration in the following steps.
5.1 Cut down the leveling paper along the dotted line and put it between the extruder and print bed. Then enter “Printer”– “Home”–“Levelling” and follow 5.2 & 5.3 steps. 5.2 If the paper can be moved easily between the nozzle and platform, you can adjust 4pcs screws anticlockwise with Hex wrench, until there is a slight resistance between the nozzle and the paper.
5.3 If the paper can’t be moved entirely, you can adjust the screws clockwise, until the paper can be pulled back and forth with slight resistance.
Leveling Paper
FCC Statement:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator& your body.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>