onn 100069443 Wireless Open Ear Earphones User Guide
- June 5, 2024
- Onn
Table of Contents
100069443 Wireless Open Ear Earphones
User Guide
Get to Know Your Wireless Open-Ear Earphones
- Model: 100069443
- Speaker Diameter: 14.2 mm
- Speaker Impedance: 320 ±15%
- Sensitivity: 120±3dB at 1KHz
- Speaker Driver Rating Power: 2mW
- Charging Cable, 9 in (23 cm)
- 48hours of total playtime (with charging case
- IPX4 Water-resistant rating applies to the earphones, not to the charging case.
What’s in the Box?
Check to make sure you have everything below
- Earphones x1 pair
- Charging case x1
- US8-C’charging cable x1
- Quick Start Guide x1 (US8-Cis a trademark of US8 Implementers Forum, Inc.)
Let’s Get Started!
First-time setup
Step 1
Drop earphones back into the charging case for initial activation and close
the charging case to fully charge. 
Step 2:
Open the charging case, earphones will be powered on and go into pairing mode
automatically, connect to your device by selecting “onn. Open Ear TWS”. 
Power on/ Power off & Pairing
Open the case Power it On automatically & connect to the last paired device
Drop them back and close the charging case, Power Off automatically &
disconnect to last paired device
Tap & Hold 4 Secs Each Side for Power On/Off (If you are carrying case) the earphones without charging
If you want to pair with another device, please turn Bluetooth off on your
last paired device if it is nearby, then opens the charging case for pairing.
Enjoy Your Music & Accepting a Call
Three part conference
Supports switching between two calls 
Charge Your Earphones
Earphones charging
Case charging
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1 ) This device may not cause harmful interference, and (2) this device must accept any interference received, including interfer ence that may cause undesired operation.
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Need help? We’re here for you every day from 7 a.m. to 9 p.m.
CST. Give us a call at 1-888-516-2630.
Produced for Walmart Inc.
Bentonville, AR 72716
Ver.01 10/10/21
FCC ID: 2ADTV-69443
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>