INSIGNIA NS-PM2HS M.2 NVMe 2280 Heat Sink User Guide
- June 5, 2024
- Insignia
Table of Contents
NS-PM2HS M.2 NVMe 2280 Heat Sink
User Guide
QUICK SETUP GUIDE
M.2 NVMe 2280 Heat Sink
NS-PM2HS / NS-PM2HS-C
PACKAGE CONTENTS
- Heat sink
- Thermal pad (2)
- Screw for heat sink (4)
- Screw for fixing PS5 and SSD
- Screwdriver
- Quick Setup Guide
Before using your new product, please read these instructions to prevent any damage.
FEATURES
- Specially designed for single and double-sided M.2 2280 or M.2 22110 SSDs, cooling down your device to a safe temperature
- Double-sided construction works with most desktop computers and PlayStation 5
- Groove design provides a 50° F ~ 68° F (10° C ~ 20° C) all-around cooling (varies depending on environment)
- Helps avoid overheating and throttling, improving the performance of your device
- Silicone thermal pads provide durability, protection, and improved heat dissipation
COMPATIBILITY
- M.2 2280 or M.2 22110 SSDs
- PS5 and desktop computers with 12 mm clearance on the motherboard
OVERVIEW
SETTING UP YOUR HEAT SINK
-
Remove the protective film from one of the thermal pads and place the pad inside the heat sink.
-
Remove the protective film from the other thermal pad, then place the pad on top of the M.2 SSD.
-
Place your M.2 SSD in the center of the heat sink by aligning the back of the SSD with the back of the heat sink.
-
Place the top cover on the M.2 SSD.
-
Use the included screwdriver and four small screws to secure both sides of your heat sink.
-
Install your M.2 SSD pin side first in your PS5 or desktop at a 30° angle. Press the other end of your M.2 SSD down until it is level. Secure it in place with the included long screw.
Note: When installing the M.2 SSD, make sure that the aluminum ferrule is
used with the long screw to provide stability and proper offset for the M.2
drive. Failure to use the aluminum ferrule can result in M.2 damage.
M.2 SSD (2280 mm)
M.2 SSD (22110 mm)
SPECIFICATIONS
Dimensions (H×W×D): 2.9 × .9 × .4 in. (7.5 × 2.4 × 1 cm) Working temperature:
32 ~ 158° F (0 ~ 70° C) Working humidity: 20% RH to 90% RH
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call
1-877-467-4289 (U.S. and Canada)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its affiliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richfield, MN 55423 U.S.A.
©2022 Best Buy. All rights reserved.
V2 ENGLISH 22-0565