Dispensor FOAMA SOD-02 WBM Smart Automatic Foaming Hand Soap Dispenser User Manual
- June 5, 2024
- Dispensor
Table of Contents
Dispensor FOAMA SOD-02 WBM Smart Automatic Foaming Hand Soap Dispenser
OVERVIEW
IMPORTANT
- DO NOT IMMERSE in water or rinse under a stream of water. The product is only water-resistant when assembled and upright.
- DO NOT FILL WITH EXFOLIANTS. Do not use with mouthwash or iquid soaps with granules, abrasives or microbeads. Do not fill with thick fluids or lotion. Keep lint, dirt, and fibers out of the bottle.
- LIQUID SOAPS MUST BE DILUTED With water. For best results, use undiluted, pre-formulated foaming soaps. TURN OFF prior to handling to avoid unwanted dispensing.
SET UP
- Insert 4 rechargeable AA batteries or 4 neN AA alkaline, batteries all from the same package, aligning polarity asindicated (not included).
ATTENTION
In exceptional circumstances, batteries may leak fluids that can cause chemical burns or damage your device. lo avoid battery leak:
- Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
- Do not mix old and/or new batteries.
- Always replace all four batteries together.
- Add foaming solution to the bottle. Always replace the bottle plug and wipe the top of the bottle dry. Do not Overkill and assemble carefully.
- To turn on, touch & hold for 2 seconds until the solid green light flashes 3 times. Repeat to turn FOAMA off, as needed, a red light will flash an then become solid momentarily onc FOAMA is off.
- Place your hand under the spout to trigger the pump. Once the liquid is added, trigger the pump until foam appears.
NOTE: For best results and easy refills, try a ready-to-use, pre- formulated foaming soap that does not require dilution.
DILUTING SOAPS
FOAMA works well with most non-granular, diluted liquid soaps. Each soap varies in the formulation and it may be necessary to try other soaps for better results. When diluting liquid soaps with water, the following mixing guide will help you find the optimal ratio.
MIXIN GUIDE
MOST LIQUID SOAPS
- To minimize waste, mix a half bottle and then test the foam. Adjust as necessary and ensure the underside of] the pump is kept dry. Swirl bottle to mix, do not shake.
VERY THICK SOAPS
- ideally, the foam will hold its shape well without any large bubbles. Some small bubbles are okay.
- If the pump is sputtering and producing large bubbles with sticky foam, add about 20% more water and test again. It may be necessary to cycle water through the pump to clear out excess concentrated soap.
- if the foam seems light, frothy, and doesn’t clean well, add a small amount of soap to give the foam more structure.
DISPENSING
- Place a hand under FOAMA’s spout to activate the touchless sensor. A green light is shown while the pump runs.
- Wait for the cycle to finish or lower hand away from the sensor to stop the cycle early.
- Quickly double-tap to activate the pump and dispense a pre-set amount of foam. This feature is disabled by LOCK and unaffected by the VOLUME setting.
- When the battery power begins to run low, a red light will flash while the pump is dispensing. New batteries may be required soon.
VOLUME
- FOAMA always defaults to the lowest volume after turning on/off Briefly touch to adjust the volume The LED will quickly blink green 1,2 or times to indicate the ne new volume setting.
SETTINGS LOCK
- While FOAMA is ON, lock touch ke by holding for 6 seconds until a green light is briefly shown. Repeat to unloCk When locked, the only touchless operation is possible, and no other changes can be made. Disable LOCK to power off. Opening the battery cover will reset the lock.
TIPS
- FOAMA is only splash-resistant when upright and fully assembled. Do not immerse in water. Wipe with soft damp] cloth to clean.
- If immersed, remove batteries and pat dry. Allow to dry disassembled overnight before reassembly. Water spray and droplets can trigger the touch button Enable LOCK or move FOAMA away from water spray.
- If FOAMA will not turn on or turn off when pumping, ensure the battery chamber is dry, check batteries for corrosion and clean thoroughly. See help videos in our FAQ. Rechargeable batteries do not corrode with proper use.
- Please Note: Some creamy soaps may separate after diluting causing inconsistent foam texture. Consider trying a different Soap. Rinse out the bottle when changing soaps.
- Twice a year, the pump should be run with clean, warm wate to rinse out all internal soap and any dried soap. See help videos in our FAQ.
STOP: PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
WE’RE HERE TO HELP!
- 1-800-487-3300
- Monday through Friday 8:30 am to 5:00 pm (ET)
- If outside North America, your local distributor contact information is available at:
- www.betterlivingproducts.ca/distributors
- If necessary, we may repair or replace this product.
BETTER LIVING
- making life a little easier
- 201 Chrislea Road, Vaughan, Ontario L4L 8N6 Canada
1 YEAR MANUFACTURER’S WARRANTY
Better Living Products warrants this product only against manufacturing defects and to perform as instructed. Better Living Products will replace the entire unit or any component deemed by the Company to be defective in manufacture, at no charge, during the warranty period. Shipping is extra. Better Living Products shall not be liable for any consequential damages in connection with the use of this product. Liability is limited to the replacement cost of this product. Any damage caused by misuse or mishandling is not covered by this warranty. The company makes no warranty, expressed or implied, except as above. warranty applies to the original purchaser only and must be supported by the original sales receipt.