DURABOOK U11I Rugged Tablet Expansion Modules User Manual

June 5, 2024
Durabook

DURABOOK U11I Rugged Tablet Expansion Modules User Manual
DURABOOK U11I Rugged Tablet Expansion Modules

Package Contents

If any of following items is damaged, please contact your retailer.

PCMCIA module
Package Contents
OR
Package Contents

CTO door plate
Package Contents

Screw & O RING
(8+6+2+8)
Package Contents

PCMCIA Module Screws

Screw Name Screw Type Quantity
ISOT-M2.0X3L 8 (CTO door plate to lower case)
ISOT-M2.6X4L 2 (module to lower case)
M2.6X12L & O RING 6 (module to lower case)

NOTE
The pictures are for reference only, actual items may slightly differ.

Installation

This section will guide you on how to install the expansion modules to your tablet PC.
Note: Make sure to remove the battery before installing any type of expansion modules. For more information on how to remove/install the battery, please refer to the tablet PC service guide.

Installing the PCMCIA Module

To install the PCMCIA module, follow the steps below:

  1. Remove the 2 screw securing the CTO door to the lower case.
    Installation

  2. Slide the CTO door to the left to disengage it from the tabs.
    Installation

  3. Remove the CTO door.
    Installation

  4. Remove the CTO door seal out of its compartment
    Installation

  5. Slide the knob to the right to unlock the CTO box door.
    Installation

  6. Open the CTO box door.
    Installation

  7. Connect the PCMCIA module harness to the mainboard connector
    Installation

  8. By aligning with the screw holes, install the CTO door plate onto its compartment on the lower case. Make sure the rubber washers are properly seated into their respective screw holes
    Installation

  9. Attach the 8 screws to secure the CTO door plate to the lower case.
    Installation

  10. Fold and place the excess cable of the PCMCIA module harness into the gap for proper cable routing.
    Installation

  11. By aligning with the screw holes, install the PCMCIA module onto its slot on the lower case
    Installation

  12. Attach the 8 screws to secure the PCMCIA module to the lower case.

    • M2.6X12L & O RING (marked with blue-white circle): 6 screws
    • ISOT-M2.6X4L (marked with orange-white circle): 2 screws
      Installation
  13. Close the CTO box door.
    Installation

  14. Slide the knob to the left to lock the CTO box door.
    Installation

PCMCIA Module Screws

Screw Name Screw Type Quantity Torque
ISOT-M2.0X3L 8 (CTO door plate to lower case) 2.0 ± 0.2 Kgf-cm
ISOT-M2.6X4L 2 (module to lower case) 2.5 ± 0.2 Kgf-cm
M2.6X12L & O RING 6 (module to lower case) 2.5 ± 0.2 Kgf-cm

Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.

P/N: 62+030970+00

© 2021 Twinhead International Corp and/or its affiliates. All rights reserved.

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals