DURABOOK R11 Rugged Tablet Expansion Module LAN User Manual
- June 4, 2024
- Durabook
Table of Contents
DURABOOK R11 Rugged Tablet Expansion Module LAN User Manual
Package Contents
If any of following items is damaged, please contact your retailer.
LAN Expansion Module Screws
Installation
This section will guide you on how to install the expansion modules to your
tablet PC.
Note: Make sure to remove the battery before installing any type of
expansion modules. For more information on how to remove/install the battery,
please refer to the tablet PC service guide.
Installing the LAN Expansion Module
To install the LAN expansion module, follow the steps below:
-
Remove the screw securing the Mylar on the DDR door.
-
Remove the mylars from the DDR door.
-
Attach the expansion sponge and four sponges to the DDR door.
-
Connect the LAN expansion module FPC to the mainboard connector.
-
By aligning with the screw holes, install the LAN expansion module bracket onto its slot on the lower case.
-
Attach the 2 screws to secure the LAN expansion module assembly to the lower case.
-
By aligning with the screw holes, place the gasket onto the LAN expansion module bracket.
-
By aligning with the screw holes, place the LAN expansion module cover on the top of the installed gasket.
-
Attach the 4 screws to secure the LAN expansion module cover to the lower case.
-
Install the battery.
LAN Expansion Module Screws
Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.