Durabook U11I Rugged Tablet Expansion Modules Card 54 User Manual
- June 5, 2024
- Durabook
Table of Contents
Durabook U11I Rugged Tablet Expansion Modules Card 54
Package Contents
If any of the following items are damaged, please contact your retailer.
Card 54 Module Screw
NOTE:
The pictures are for reference only, actual items may slightly differ
Installation
This section will guide you on how to install the expansion modules to your
tablet PC.
Note: Make sure to remove the battery before installing any type of
expansion modules. For more information on how to remove/install the battery,
please refer to the tablet PC service guide.
Installing the Card 54 Module
To install the Card 54 module, follow the steps below:
- Remove the 2 screw securing the CTO door to the lower case.
- Slide the CTO door to the left to disengage it from the tabs.
- Remove the CTO door
- Remove the CTO door seal out of its compartment.
- Slide the knob to the right to unlock the CTO box door
- Open the CTO box door.
- Connect the Card 54 module harness to the mainboard connector.
- By aligning with the screw holes, install the CTO door plate onto its compartment on the lower case. Make sure the rubber washers are properly seated into their respective screw holes.
- Attach the 8 screws to secure the CTO door plate to the lower case
- Fold and place the excess cable of the Card 54 module harness into the gap for proper cable routing.
- By aligning with the screw holes, install the Card 54 module onto its slot on the lower case.
- Attach the 8 screws to secure the Card 54 module to the lower case.
- M2.6X12L & O RING (marked with a blue-white circle): 6 screws
- ISOT-M2.6X4L (marked with an orange-white circle): 2 screws
- Close the CTO box door
- Slide the knob to the left to lock the CTO box door
Card 54 Module Screws
Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>