EKSA Telecom H1 Bluetooth Wireless Trucker Headset Instruction Manual
- June 3, 2024
- EKSA Telecom
Table of Contents
EKSA Telecom H1 Bluetooth Wireless Trucker Headset Instruction Manual
www.eksatelecom.com
info@eksatelecom.net
IMPORTANT SAFETY INSTRUCTIONS
Please read and keep all safety and use instructions.
WARNINGS/CAUTIONS
-
Do NOT use the headphones at a high volume for any extended period.
– To avoid hearing damage, use your headphones at a comfortable, moderate volume level.
– Turn the volume down on your device before placing the headphones in/on your ears, then turn the volume up gradually until you reach a comfortable listening level. -
Do NOT use your headphones while driving for phone calls or any other purpose.
-
Do NOT use the headphones at any time the inability to hear surrounding sounds may present a danger to yourself or others, e.g., while riding a bicycle or walking in or near traffic, a construction site or railroad, etc.
– Remove the headphones, to ensure you can hear surrounding sounds, including alarms and warning signals.
– Be aware of how sounds that you rely on as reminders or warnings may vary in character when using the headphones. -
Do NOT use the headphones if they emit any loud unusual noise. If this happens, turn the headphones off and contact EKSAtelecom customer service.
-
Remove headphones immediately if you experience a warming sensation or loss of audio.
-
Do NOT use mobile phone adapters to connect headphones to airplane seat jacks, as this could result in injury or property damage due to overheating.
-
Do NOT use the headphones as aviation communication headsets except in case of emergency.
– No incoming audio will be heard with a discharged or improperly installed battery. This could result in the potential of missed communications while piloting an aircraft.
– Extremely loud ambient noise levels common to many propeller-driven aircraft may impair your ability to receive incoming audio communications, particularly during takeoff and climb out.
– The headphones are not engineered for noise conditions, altitude, temperature or other environmental conditions common in non-commercial aircraft, resulting in possible interference to critical communications. -
To reduce the risk of fire or electrical shock, do NOT expose this product to rain, liquids or moisture.
-
Do NOT make unauthorized alterations to this product.
-
Use this product only with an agency approved power supply which meets local regulatory requirements (e.g., UL, CSA, VDE, CCC).
-
Do not expose products containing batteries to excessive heat (e.g. from storage in direct sunlight, fire or the like).
REGULATORY INFORMATION
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by YI ZHAO (SHENZHEN) CO., LIMITED could void the user’s authority to operate this equipment.
This device complies with part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation. This device complies with FCC and Industry Canada
radiation exposure limits set forth for general population. It must not be co-
located or operating in conjunction with any other antenna or transmitter.
Meets IMDA Requirements.
CAN ICES-3 (B)/NMB-3(8)
Management Regulation for Low-power
Radio-frequency Devices
Article XII
According to “Management Regulation for Low-power Radio-frequency Devices”
without permission granted by the NCC, any company, enterprise, or user is not
allowed to change frequency, enhance transmitting power or alter original
characteristic as well as performance to an approved low power radio-frequency
devices.
Article XIV
The low power radio-frequency devices shall not influence aircraft security
and interfere legal communications; If found, the user shall cease operating
immediately until no interference is achieved. The said legal communications
means radio communications operated in compliance with the Telecommunications
Act.
The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices.
DON’T attempt to remove the rechargeable lithium-ion battery from this product. Contact your local EKSAtelecom retailer or other qualified professional for removal.
YI ZHAO (SHENZHEN) CO., LIMITED hereby declares that this product is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU and all other applicable EU directive requirements. The
complete declaration of conformity can be found
at: www.eksatelecom.com
For Europe:
Frequency band of operation
2400 to 2483.5 MHz:
Bluetooth: Maximum transmit power less than 20dBm EIRP.
Please dispose of used batteries properly, following local regulations. Do not incinerate.
REGULATORY INFORMATION
This symbol means the product must not be A discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
Removal of the rechargeable lithium ion battery in this product should be
conducted only by a qualified professional.
Please contact your local EKSAtelecom retailer or see
https://www.eksatelecom.com for further information.
Charging temperature range: 0º C – 45° C
Discharging temperature range: -20º C – 60° C
[EC|REP] C&E Connection E-commerce (DE) GmbH
Add.: Zurn Linnegraben 20, 65933, Frankfurt am
Main, Germany
Tel.: +4906927246648
Email: info@ce-connection.de
[UK|REP] APEX CE SPECIALISTS LIMITED
Add.: 89 Princess Street, Manchester, M1 4HT. UK
Tel.: +441616371080
Email: info@apex-ce.com
Manufacturer: YI ZHAO (SHENZHEN) CO., LIMITED
Add.: 6th Floor, T3 Creative Building, Shenzhen Colorful Huiwei Cultural and
Creative Expo City, No.5010 Baoan Avenue, Caowei Community, Hangcheng Street,
Baoan District, Shenzhen City, Guangdong Province, China
Manufacturer’s Name: YI ZHAO (SHENZHEN) CO., LIMITED
Manufacturer’s Address: 6th Floor, T3 Creative Building, Shenzhen Colorful
Huiwei Cultural and Creative Expo City, No.5010 Baoan Avenue, Caowei
Community, Hangcheng Street, Baoan District, Shenzhen City, Guangdong
Province, China
UK compliance statement: YI ZHAO (SHENZHEN) CO., LIMITED Hereby declares that
this device is in compliance with the essential requirements and other
relevant provisions of the UK Radio Equipment Regulations 2017 (SI 2017/1206).
A copy of the UK declaration of the conformity is available online at
www.eksatelecom.com
info@eksatelecom.net
Bluetooth:
Banda de frecuencia de funcionamiento 2400 a 2483,5 MHz:
Bluetooth: Potencia maxima de transmision inferior a 20 dBm EIRP.
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The EKSAtelecom H6 Headset has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
The Bluetooth Adapter complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of 20 cm between the
radiator and your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
FCC ID: 2A25A-H6F
FCC ID: 2A25A-H6
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>