ANKER 622 Magnetic Battery MagGo User Manual

ANKER 622 Magnetic Battery MagGo

At a Glance

The fold-out stand can be unfolded and used as a stand during wireless charging.

Charging Your Device Wirelessly and Recharging Your Portable Charger

Simultaneously

Charging Your Phone or Earbuds Using a Charging Cable

Recharging Your Portable Charger

Note: When your PowerCore exceeds the temperature limit, the battery level indicator will turn off. Let PowerCore cool down before use.

Charging the iPhone 12 Series or Later

1. To activate wireless charging, press the power button or place your device on the charger
as illustrated below and it will be held in place magnetically.

Specifications

saftey

• This wireless charger is not compatible with non-MagSafe phone cases, such as Otterbox Defender
• Do not use an adapter with an output of 5V/1A (5W) or
• Wireless chargers make charging more convenient than wired chargers, but confined by current wireless technology, their charging speed is slower than that of wired
• High temperatures will reduce charging speed and restrict power, which is something that happens to all wireless It is recommended that you charge your device in environments with temperatures below 25°C / 77°F.
• Both the protective phone case and the position of your device on the wireless charger will affect the charging speed. The farther it is placed from the center of the wireless charger, the slower the charging speed will

  IMPORTANT SAFETY INSTRUCTIONS

When using this product, basic precautions should always be followed, including the following:

• Store the product in a cool, dry
• Do not store the product in a hot or humid
• Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to
• Operating temperature should be between 0°C to 40°C / 32°F to 104°F.
• Do not disassemble the Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
• If the product is not used for long periods of time, you should charge and discharge it once every three
• When charging a device, the product may feel This is a normal operating condition and should not be a cause for concern.
• In normal conditions, the battery performance will decline over several
• Do not dispose of the product in heat or
• Do not clean the product with harmful chemicals or
• Misuse, dropping, or excessive force may cause product
• When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each
• Be aware that a discharged battery may cause fire or Tape the terminals to insulate them.

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

(1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio / TV technician for help.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your body.

Product Name: Anker 622 Magnetic Battery (MagGo) Model: A1611

The following importer is the responsible party (for FCC matters only). Company Name: Fantasia Trading LLC

Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764 Telephone: +1 800 988 7973

IC  Statement

This device complies with RSS-216 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference.

Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1611 is in compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.anker.com/ 

support@anker.com
support.mea@anker.com (For Middle East and Africa Only)

References

• Anker | Live Charged. - Anker Australia

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>