MICRO TECH ZMC16 Autolock Car Mount Dashboard Phone Holder User Manual
- June 5, 2024
- MICRO TECH
Table of Contents
TECH ZMC16
Autolock
Car Mount Dashboard Phone Holder
User Manual
ZMC16 Autolock Car Mount Dashboard Phone Holder
|
---|---
INTRODUCTION
Auto-Lock Car Dashboard Mount is the last mount you’ll need to purchase. The sleek black design ensures that it matches every dashboard and car environment It is put into. It can bend in all different types of directions so you could place it and use it however you would like. The suction cup doesn’t only suck the product to the dashboard or windshield but it also has a sticky adhesive on it that way there is no possible chance it could fall or tip over in the middle of your journey.
PACKAGE CONTENTS
- lx Clamp and Release Phone Holder
- lx Socket
- lx Back connector
- I x Suction Cup Stand
PRODUCT OVERVIEW
SPECIFICATIONS & FEATURES
Mount Body is 6 cm x 10.5 cm with a 3.5 cm depth
The adjustable clamp can go from 5.5 cm to 9 cm
The wings expand to 10.5 cm
The stand is normally 12 cm tall
It can extend in height to 16 cm
The suction cup is 6.5 in diameter
The phone holder feet are 3 cm wide
Strong and secure suction cup to stick to any flat surface
Tight-fitting clamp with rubber grips
Quick-Use Spring-loaded clamping mechanism
Extendable Arm for optimal viewing angle 360° rotating phone bracket
Easy Installation
Sticky suction cup
Can adhere to windshield or dashboard
HOW TO USE
Constructing the Mount
- Unbox all pieces and make sure you have everything
- Take flat pieces and connect pieces into holes on the back of the mount and then slide up to secure
- Screw joint part onto the back of the mount body but loosely
- Leaving it loose will allow for the ball to pop in easily
- Once the ball is in the socket tighten the knob to make sure its tight
- Take plastic to peel off of the suction cup
- Place the mount on the dashboard or windshield in the desired location
- Squeeze the wings in to expand the clamp
- Put the phone in the clamp and press it towards the back of the mount to close the clamps and tighten in
- Pull down the lever on the bottom of the stand to make sure that the suction is extra secure
- Squeeze wings again to release the phone
CARE AND SAFETY
- Do not use this unit for anything other than Its intended use.
- Keep the unit away from the heat source. direct sunlight humidity, water or any other liquid.
- Do not expose the device to extremely high or low temperatures, as it may damage the battery.
- Do not operate the unit if it has been wet or moist to prevent electric shock and/or injury to yourself and damage to the unit
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- Keep the unit out of reach of children.
- This unit is not a toy.
BATTERY DISPOSAL:
This product contains a lithium polymer battery. Lithium polymer batteries are environmentally safe when fully discharged. Please refer to your local and state laws for battery disposal procedures.
©SMTEK GROUP INC.,
All rights reserved. MicroTech is a trademark of SM TEK GROUP INC.
All trade names are the registered trademarks of the manufacturers listed.
New York, NY 100011
www.smtekgroup.com
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>