CHAINWAY CP30 Handheld Computer User Guide
- June 5, 2024
- CHAINWAY
Table of Contents
CP30 Handheld Computer
User Guide
Shenzhen Chainway Information Technology Co., Ltd.
Add: 9F Building2, Phase2, Gaoxinqi Industrial Park, Baoan District, Sher
E-mail: support@chainway.cn
Web: www.chainway.net
Packing List
Note: The packing materials are actually based on the order.
Appearance and Components
■ Front View
**■ Rear View
Note: The views above are for your reference. Ports vary by your
choice.
■ Inside View
**
USB Connection
- Connect the AC adapter to the power receptacle.
- Connect the power cord to the AC adapter.
- Connect the other end of the power cord to the outlet.
Loading the Roll
-
Press to open the printer cover and mechanism.
-
Pull the roll holders open and place the roll between them. Press down the locking tab.
-
Pass the labels through label guides and adjust label guides to the label s width.
Loading the Ribbon
-
Install the ribbon module.
-
Insert the left part of the supply spindle and then the right part spindle.
-
Press down the printer mechanism.
-
Insert the left part of rewind spindle and then the right part.
-
Wind the core 2-3 circles until the ribbon is pulled tightly.
-
Press down the mechanism and close the cover.
Note: Please refer to a windows drive
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance between 20cm from the radiator and your body.
FCC ID: 2AC6A-CP30
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>