BrandsEgo E66 TWS Wireless Bluetooth Earphone User Manual
- August 22, 2024
- BrandsEgo
Table of Contents
BrandsEgo E66 TWS Wireless Bluetooth Earphone
Product Specifications
- Model: E66
- Function : T2
- Charging Time : 3 seconds for power on, 5 seconds for power off
- Control: L/R ear
- Special Feature : Voice assistant support
FAQ
- Q : How do I reset the factory settings?
- A : If the left and right ears are not synchronized, click the left ear 6 times to restore factory settings.
- Q : How do I activate the voice assistant feature?
- A: Triple-click either the L/R ear to activate the voice assistant feature.
Product Description
- Mode : E66
- Bluetooth 5.3
- Impedance: 320
- Speaker diameter: 8 mm
- Wireless range: 15-20 Meters
- The earphone battery: 30mAh
- Charging case: 300mAh
- Battery charging time : 1-2 Hours
- Work time over 4-5 Hours
T2 Function Description
Remarks: The product is updated from time to time, and some functional operations will be changed due to different versions. Please refer to the actual operation.
Notes
- Please store and use this product in a normal temperature environment;
- Do not expose this product to rain or humid environments;
- Do not throw it to avoid product damage caused by falling;
- Do not disassemble, repair, or modify this product by yourself;
- Do not use chemical solvents to wipe this product;
- Do not discard at will, or in high temperature (temperature higher than 60 degrees) and fire, so as not to cause danger!
- Bluetooth products are affected by the environment and distance, please do not get close to the large electromagnetic field interference and radiation environment.
- If the Bluetooth headset is not used for a long time, please fully charge it and charge it once a week to check the service life of theBluetooth headset.
- if the left and right ears are not synchronized, the headset is not connected to the mobile phone state, and the left ear has 6 clicks to restore factory Settings.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>