BHflex WC510MVV20 Vehicle Installed Wireless Charging System User Manual

June 5, 2024
BHflex

Installation & User manual

BHflex WC510MVV20 Vehicle Installed Wireless Charging
System

  1. Put your phone on a wireless charging pad directly and on the center of the charging pad.
  2. Check the phone if it was charged or not. you can check on the mobile phone screen

If the phone was not charged, please try to put your phone on the charging area again.

  • Mainly this wireless charging unit can be used for wireless charging mobile phones.
  • Also can charge all devices to meet WPC(Qi) standards

This device can be operated in at least one member state without infringing applicable requirements on the use of radio spect rum.

FCC, IC Compliance statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1.  This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.
    Changes or modifications not expressly approved by the manufacturer (or party responsible) for compliance could void the user’s authority to operate the
    equipment.

FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 15 cm between the radiator and your body.
IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 15 cm between the radiator & your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device contains a license-exempt transmitter(s)/receiver that complies with Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals