KUSTOM Raptor RP-1: Dash Mounted RADAR for Police Car User Guide

June 5, 2024
Kustom

KUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-for-Police-Car-
logo

KUSTOM Raptor RP-1: Dash Mounted RADAR for Police Car

KUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-for-Police-Car-
product

Raptor RP-1 Display Control Panel

KUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-
for-Police-Car-fig-1

Button Function

  • Press and hold to turn the Raptor RP-1 on/off.
  • Single press to control display backlight.
  • Lock/release the active antenna.
  • Up control in menus.
  • Toggle on/off selected antenna transmit.
  • Down control in menus.
  • Menus
  • Enters a selection in menus.
  • Manual Test
  • Patrol Speed Blank with the locked target.

Raptor RP-1 Display

Stationary DisplayKUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-for-Police-Car-
fig-7

Moving Opposite DisplayKUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-for-Police-
Car-fig-8

Same Direction DisplayKUSTOM-Raptor-RP-1-Dash-Mounted-RADAR-for-Police-
Car-fig-9

Raptor RP-1 Menus

  • Main Menu: Top-level menu including Audio Volume and Squelch Control, Range Control, and Patrol Speed Minimum.
  • Operations: Select Antenna, Mode, Toggle Fastest, and Audio Squelch Control.
  • Display: Day/Night Display, Factory Reset, Contrast, and Manual or Automatic Backlight Control.
  • Advanced: VSS Setup, Options, Time/Date, System, and Diagnostics.
  • Options Setup: Units, Auto-Unlock, Min Audio, Left or Right Hand Drive, In-Car Video Output Protocol, Toggle on/off Certify Fail, Toggle on/off Fork Test Fail.
  • System: DSP and Display Firmware Version, Front and Rear Antenna Type, VSS Sync Value, Enabled Features.

Accuracy Tests

  • Automatic Self: Test Raptor RP-1 performs an internal accuracy test at power-up and every five (5) minutes while powered. Internal accuracy tests are performed with every mode change and locked target.
  • Manual Self: Test Press the test button to initiate the internal accuracy, display tests, and prompt for fork test.
  • Fork Tests: Press the test button. “FORK TEST” will be displayed in the message area for 30 seconds. Lightly ring the low and then high fork by striking a non-metal surface. Test the desired modes of operation and front and/or rear antennas. Verify target speed displayed is +/- 1 mph (+/- 1 km/h) value stamped on fork.
  • Assisted Fork: Tests The Raptor RP-1 is offered with an optional enhanced “AssistedTuning Fork Test” feature that guides the operator through the test procedure and clearly indicates pass/fails.

Note: Due to the ability of the Raptor RP-1 to reject non-directional signals, the operator must place the unit in the FORK TEST mode to read tuning forks.

Raptor RP-1 Remote Controls

The Raptor RP-1 may be equipped with wired remote control, shown below, or wireless remote control. The wired remote control features backlit buttons, while the wireless remote control has glow in the dark buttons.KUSTOM-
Raptor-RP-1-Dash-Mounted-RADAR-for-Police-Car-fig-11

contacts

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals