Olight valkyrie turbo User Manual
- June 5, 2024
- OLIGHT
Table of Contents
Olight valkyrie turbo
Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!
IN THE BOX
SPECIFICATIONS
The results are given based on tests using two 3V 1600mAh CR123A batteries. The tests obey ANSI/NEMA FL1 standard.
Max Output: ≤0.35mW@455nm Wavelength
PRODUCT OVERVIEW
BEFORE FIRST USE
Please open the tailcap as shown in the picture. Remove the insulating film
and close the tailcap.
- Open the tailcap
- Remove the insulating film
BATTERY INSTALLATION
- Pull up the spring lock door and open the tailcap. Place the batteries inside the body following the direction of the positive and negative marks.
- Hold the tailcap down firmly, and then close the spring lock.
AVAILABLE BATTERIES
2 x CR123A
LIGHT INSTALLATION
Open the swing arm as shown below. Make sure that the adapter fits inside your rail notch. Close the swing arm once it is aligned.
Pull open the swing arm
Close the swing arm
COMPATIBILITY CHECK:
The Valkyrie Turbo can be used on most Glock or Picatinny (MIL-STD-1913) type
rails. The Glock adapter labeled “GL” is already installed and a Picatinny
(MIL-STD-1913) adapter is included in the package. To install the light on
Picatinny (MIL-STD-1913) rails, the user needs to replace the “GL” adapter
with the included 1913 adapter using the screws and wrench provided in the
package.
DANGER
- DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
- DO NOT cover the flashlight’s head or place the head on the ground when the flashlight is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
- DO NOT use the battery if its wrap is broken.
WARNING
- Keep out of reach of children. The surface of the flashlight may reach 50 °C or above when the flashlight is turned on for an extended period of time. Please don’t touch it to avoid burning your skin.
- DO NOT disassemble the product. The disassembling may cause irreversible damage.
- If the product is left unused, please remove the batteries and store them separately.
- LEP light is bright and blinding – DO NOT shine at aircraft or vehicles at any distance.
NOTICE
- Please pay attention to the battery polarities during installation. There are signs for the battery polarity position on the inside of compartment cover.
- The switches of Valkyrie Turbo are better protected from drops when the product is properly mounted to the rail of your setups.
- At room temperature, the light will work at the top output mode for 3.5 minutes and gradually step down to 60 lumens within 0.5 minutes.
- NOT compatible with RCR123A battery
RISK GROUP 2
CAUTION Possibly hazardous optical radiation emitted from this product. Do not
stare at operating lamp. May be harmful to the eyes.
WARNING
Complies with IEC 60825-1:2014 Class 1 and IEC 62471 Group 2. Report Number is
6818421136401. December 28, 2021.
HOW TO OPERATE
CONSTANT ON/OFF :
Single press either side of the tail switch for constant on. While the light
is on, press either side of the tail switch again to turn it off.
MOMENTARY ON :
Press and hold down either side of the tail switch for momentary-on. Let go of
the switch and the light will turn off.
STROBE :
To enter strobe mode, please press both sides of the tail switch and release,
or press and hold one side and then press the other and release. When in
strobe mode, press either side of the switch to turn it off.
References
- Olight | Illuminate Your World.
- Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>