SyberSense XPR01 Recessed Door Sensor User Manual
- June 5, 2024
- SyberSense
Table of Contents
SyberSense XPR01 Recessed Door Sensor
Part number:
Recessed Door Sensor, White (XPR01-E-1433-00)
Features description:
The SyberSense Products Recessed Door Sensor XPR01 is designed for indoor
residential and light commercial use. This Door sensor can be easily mounted
on doors, as well as other devices that open and close.
It communicates with SyberSense Control Panels over 433 MHz frequency. The
sensor supports two loops. Signals are transmitted to the alarm control panel
when the magnet is moved away from or closer to the sensor (loop 2).
Specifications:
FCC compliance
FCC ID: 2AVDCXPR01-E-1433
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co- located or
operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>