GAFres Z1 LED Bluetooth Beanie Hat User Guide
- June 5, 2024
- GAFres
Table of Contents
Z1 LED Bluetooth Beanie Hat
User Guide
Z1 LED Bluetooth Beanie Hat
Product Name : LED Bluetooth Beanie Hat
Model No.:Z1
LED LIGHT FUNCTIONS
Press the power button on the LED light to turn on and toggle between 3 light
intensity levels.
HIGH / MEDIUM / LOW
BLUETOOTH
To connect via Bluetooth with your device, press and hold the button. The
headset will power on and say: “pairing” Go to your device’s Bluetooth
settings and select “BT-01”. Once paired the headset will say: “Your headset
is connected”. You can now listen to music and answer calls.
BLUETOOTH HEADSET FUNCTIONS
Power on / off (press & hold) Play / Pause (press) Answer / Hang up Calls
(press)
Volume down (press & hold) Previous Song (press) Volume up (press & hold) Next
song (press)
CHARGING
To charge the LED light, simply remove it from the hat and take off the protective USB cover to reveal the connector. Charge directly in any USB port for up to 2 hours. To charge the Bluetooth headset, it is recommended to remove this from the hat also. Use the micro usb cable supplied and charge in any USB port.
WASHING
Pull the fold of the hat down and push the light inwards to remove it. To
remove the Bluetooth headset, simply slide it out of its pocket and take care
not to damage the wire. The hat can be hand washed when these are removed.
DO NOT WASH WITH LIGHT AND HEADSET STILL ATTACHED.
TECHNICAL SPECIFICATION
| BATTERY | RECHARGEABLE 250mAH |
|---|---|
| POWER TIME (MINUTES) | 50L – 80M I 25L-150M I 12L-300M |
| RECHARGE TIME | UP TO 2 HOURS |
| LUMEN | 50 LUMEN |
| IP RATING | IP 44 – WEATHER RESISTANT |
| BLUETOOTH VERSION | BLUETOOTH 5.0 |
| PLAY TIME | APPROX 5HR |
| WIRELESS RANGE | 10M / 33FT |
Hand Wash Separately 
Remove LED and headset before hand washing
Packaging: Cardboard Widely recycled
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
FCC ID：2A7MSZNLZI
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>