DRAGONGLASS Pro 1200Mbps Wireless Amplifier 2.4G Wifi Repeater Pro Installation Guide
- June 5, 2024
- DRAGONGLASS
Table of Contents
SUPALILOG-XXXX
WI Fl Repeater Pro
Quick Installation Guide
Pro 1200Mbps Wireless Amplifier 2.4G Wifi Repeater Pro
1. Plug the device into a wall socket. You will find the signal
“SUPALILOG-2.4G
”and “SUPALILOG-5G-2 from your mobile WLAN list or PC. Then click
anyone.| 2. Click the “Start”.
If it cannot automatically, please the Web browser and then input
“192.168.8.1”, it you can also find the “Start”.
---|---
| 
3. On the page, you can set a password (more than 5 numbers or letters), and
then click “Next”.| 4. Select your wifi router’s SSID from the list. Then
click “Next”
| 
5. Input the password of your extended wifi router. (The password is your
original wifi password.) Then click “Next”| 6. Finished setting, please find
the new wifi name “####
PLUS ” and “####-5G PLUS”, you can connect the internet.
| 
Product Description
| Product name | 1200Mbps Wireless amplifier 2.4G Wifi Repeater 5G |
|---|---|
| Frequency range | 2.4-2.4835GHz&5G |
| Type | Wireless WiFi booster wifi repeater |
| Voltage support | 100-240V AC |
| Plug type | US/ EU /AU /UK |
| Color | White /Black |
| Storage temperature | 40ºC~T0ºC (-40F~158F) |
Features
- All goods is brand new
- It Can improve wireless coverage in all WLAN networks.
- Access to the Internet for computers and mobile phones located on the edge or outside of the range of your access point.
- Complies with IEEE802.11 n,IEEE 802.11 g,IEEE 802.11 b standards.
- Provides up to 1200Mbps transmission rates.
- Support2.4GHz and 5G WLAN networks.
- Maximum WLAN security with WPA2, WEP(128/64)
RF exposure statement
This equipment complies with the FCC RF radiation exposure limits set forth
for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and any part of your body.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
The device is restricted to indoor use only when operating in the 5150 to 5250
MHz frequency range.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>