Test Equipment Depot SGD28M PanelPilot M 2.8-Inch Graphic Panel Meter User Guide
- June 5, 2024
- Test Equipment Depot
Table of Contents
Test Equipment Depot SGD28M PanelPilot M 2.8-Inch Graphic Panel Meter
Getting to know your display
All PanelPilot compatible displays share the following features:
Mounting
Your display can be mounted in a panel up to 3mm deep. We recommend using the silicone seal provided for panels of 2mm or less. Please consult the Mounting section of the appropriate data sheet for exact cut-outs and mounting methods for your display.
Screw Terminal Connection
There are four screw terminals for connecting single and dual input applications. They are labelled 1 to 4 as follows:
N.B. For safety reasons, the meter should be isolated from both the supply and signal voltages before connecting the USB.
Default Configuration
Each display is supplied pre-configured as a 0 to 10V d.c. single-ended
combined analogue and digital voltmeter.
Connection should be made via the screw terminals as follows:
| 1 | IN2 | No connection |
|---|---|---|
| 2 | IN1 | Connect to 0 to 10V d.c. signal voltage |
| 3 | 0V | Connect to 0V |
| 4 | V+ | Connect to 4 to 30V d.c. supply voltage |
Please consult the Applications section of the appropriate data sheet for further details of wiring schemes, cautions, etc
What’s in the box?
- Panel meter
- Fixing kit
- Quick start guide
Accessories
- CABLE USB A-MF (standard miniUSB cable)
Configuring your display
-
Download PanelPilot M software onto your PC.
-
Remove rear panel to access USB port and connect the device to your PC using the CABLE IP-12W-RA (not supplied).
-
Open up the software on your PC and follow step-by-step instructions for configuring your display.
Dual-In-Line IDC (DIL Connector)
The DIL IDC socket provides an alternative connection method to the screw-
terminals. It also includes provision for future expansion using data buses
and alarm outputs. Visit www.panelpilot.com for
information on which features are currently supported. The pin-out is as
follows:
