VISION TECH SHOP TPD Series Interface Scale User Manual

VISION TECH SHOP TPD Series Interface Scale

CALIBRATION

1. ZERO
   Press key to turn on the scale.

2. TARE
   key during that start up ,display will be show “FO bL”

3. TARE
   key until display show “EECH” Before enter the tech parameter,it’s required to press the calibration switch, switch is locating below the scale

4. ZERO
   Press ON/OFF key to confirm and display will be shown “APProu”

5. TARE
    Press key to select “PI CAL”

6. ZERO
   Press ON/OFF key to confirm, display will be shown “LAL Lb”

7. TARE
   key to select “LAL L6” or “CAL FC”

8. ZERO
   ON/OFF Press key to confirm, display show “UnloRd”

9. ZERO
   ON/OFF Press key, display will be shown current calibration weight value

10. ERO
    If necessary press key to shift location,press key to change the value.

11. ZERO
    Press ON/OFF key to confirm,display will be show “LoAd” place the test weight on the platter.

12. ZERO
    ON/OFF  Once the stable indicator is shown on the display, press key, the display will be show “PH55” and come to normal weighing mode. In case the display will show any error message or incorrect measurement, repeat the calibration again.

Full Capacity

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>