Wahu BMA151 Zoingo Boingo Instruction Manual

: June 5, 2024
: Wahu

Table of Contents

Wahu BMA151 Zoingo Boingo
ASSEMBLY AND SAFETY TIPS (Adult assembly required)
REMEMBER THESE SAFETY TIPS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Wahu BMA151 Zoingo Boingo

Wahu-BMA151-Zoingo Boingo-product

ASSEMBLY AND SAFETY TIPS (Adult assembly required)

STEP 1. Partially inflate the Zoingo Boingo Ball
Using a manual air pump, carefully insert the tip of the inflation pin into the ball’s valve opening. Inflate the Zoingo Boingo Ball just until it loses its flattened shape. Carefully remove the inflation pin from the ball valve.

STEP 2. Insert the Zoingo Boingo Ballinto the platform.
With its valve side up, carefully insert the Zoingo Boingo Ball into the middle of the platform. The Zoingo Boingo Ball is in the correct position when its raised rim presses up against the platform’s center rim.

Value Opening

Platform Rim
Ball Rim

STEP 3. Finish pumping
Re-insert the inflation pin. Continue to inílate the Zoingo Boingo Ball until it is firm and the bottom ball surface fits the curved edge of the enclosed Inflation guide. The inflation guide measures the maximum inflated ball size. To make it easier for some users to balance or for a softer bounce, release air from the ball to make it smaller. Adjust as needed.

REMEMBER THESE SAFETY TIPS

Check your Zoingo Boingo before each use. Wipe away dirt and grime to prevent slipping. Do not use if any parts that show signs of abrasion, tearing, cracking or weakness.
Always use your Zoingo Boingo Pogo with the Zoingo Boingo Ball properly inflated and positioned correctly.
Never over-inflate the Zoingo Boingo Ball! This may damage the ball or cause it to burst. Use a manual hand or foot pump. Do not use an electric pump or air compressor.
Remember that the Zoingo Cord” is elastic. If stretched and released, it could snap back and cause injury.
Never swing your Zoingo Boingo around by its handle or elastic cord.
Use your Zoingo Boingo only in areas free of obstacles. Use only on dry, smooth, flat, paved surfaces and grass. Do not use it near roadways, steps, slippery surfaces, or other potential hazard areas.
Always wear protective gear and clothing, including properly fitting helmets and sneakers.
Always use common sense when jumping with the Zoingo Boingo Pogo! Jump with care, and don’t attempt tricks beyond your ability.
Do not exceed the maximum weight load of 65 kgs (143 lbs).
ATTENTION: PLEASE KEEP ZOINGO BOING0 OUT OF DIRECT SUNLIGHT WHEN NOT IN USE TO KEEP IT FUNCTIONING PROPERLY. CAUTION- The elastic cord in this product contains natural rubber latex, which may cause allergic reactions in some individuals.

HELPFUL HINT: If the Zoingo Boingo Ball loses air frequently, follow these simple steps:

STEP 1. Fill the end of the inflation pin with petroleum jelly (e.g. Vaseline brand) before attaching it to your air pump.
STEP 2. Insert the inflation pin halfway into the Zoingo Boingo Ball valve (as shown), and pump slowly 4 times. This will coat the inside of the air valve with petroleum jelly and prevent air loss.
STEP 3. Full insert the inflation pin into the Zoingo Boingo Ball and pump until inflated as described in Step 3 above.