caple CGI921 Island Hood Stainless Steel Instruction Manual

caple CGI921 Island Hood Stainless Steel

INTRODUCTION

Thank you for choosing this Caple extractor hood. To ensure that you get the best results from your new extractor hood, we strongly suggest that you read this instruction manual thoroughly before use. If treated with care, your Caple product should give you years of trouble-free use. To register ownership, please ensure you complete and return the guarantee card supplied with the appliance or visit www.caple.co.uk and register here. This instruction manual is designed to provide you with all the required information related to the installation, use, and maintenance of the appliance. This island extractor is designed to extract unpleasant odors and cooking vapors from the kitchen. In order to operate the unit correctly and safely, please read this instruction manual carefully before installation and use. Please read this manual carefully before using your appliance. It contains important safety advice; it explains how to use and look after your appliance so that it will provide you with many years of reliable service. Should a fault arise, please first consult the “Troubleshooting” section. You can often rectify minor problems yourself, thus saving unnecessary service costs. Please keep this manual in a safe place and pass it on to new owners for their information and safety.

IMPORTANT

This appliance must only be used for the purpose it is intended. Other types of use are not permitted and may prove dangerous. Caple will not be held liable for any damage caused by the incorrect use of the appliance. Do not use any accessories or attachments not recommended by Caple as this may result in fire, electric shock, or injury. To protect against fire, electrical shock, and injury to persons, do not immerse cords or plugs in water or any other liquid. Never touch the appliance with wet or damp hands. Never pull the power cable as you could damage it. If the appliance is faulty, do not attempt to repair it. Isolate it from the mains electric supply and contact Caple Service either by phone at 0117 938 7420 or email service@caple.co.uk Keep all packaging (including plastic bags, polystyrene foam, etc) out of the reach and away from children. Do not rest large or unstable objects on any part of the appliance. Caple cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that Caple reserve the right to invalidate the guarantee supplied with this product following the incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel.

SAFETY INSTRUCTIONS

• Never let children operate the
• The cooker hood is for home use only, not suitable for barbecuing, restaurants, or other commercial
• The cooker hood and its filter should be cleaned regularly in order to keep them in good working condition.
• Clean the cooker hood according to the instruction manual to reduce the risk of fire.
• When using a gas hob, do not leave naked flames under the extractor.
• Before connecting this appliance check that the power supply cord is not damaged.
• If the room where the hood is to be used contains a fuel-burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type. If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.
• The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
• Regulations concerning the discharge of air have to be conformed to.
• Do not flambé under the cooker
• Never leave frying pans unattended during use as over-heated fats and oils may catch fire.
• To ensure the best performance, we recommend switching on the extractor 15 minutes before cooking and leaving it running 15 minutes after. This will ensure that the air in the kitchen is being circulated before cooking commences and the air is being cleaned after cooking has finished.
• The performance of your extractor will vary depending on a number of factors. These include the type of extraction, room volume, length of ducting, ventilation available, and the cleanliness of the filters.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Cleaning and user maintenance must not be made by children without supervision.
• Never immerse the appliance in
• To avoid all risks, if the power cable is damaged, it must only be replaced by a Caple-appointed engineer.
• Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children must not play with this
• When not in use and before cleaning, always isolate the appliance from the electrical supply.

WARNING

• Only plug this unit into a properly earthed outlet. If in doubt seek advice from a suitably qualified engineer.
• Failure to follow these instructions can result in death, fire, or electrical shock.
• This appliance must be connected to the mains by a competent person. We recommend that the appliance is connected by a qualified electrician who is a member of the N.I.C.E.I.C and will comply with the I.E.E and local regulations. Electrical information can be found on the rating plate.

APPROPRIATE   USE

• This appliance is intended to be used in household and similar applications such as:
  • Staff kitchen areas in shops, offices, and other working environments.
  • Farm Houses.
  • By clients in hotels, motels, and other residential-type environments.
  • Bed and breakfast type environments

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. This appliance is marked according to the European directive on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about the treatment, recovery, and recycling of this product, please contact your local council, your household waste disposal service, or the retailer where you purchased the product.

WARRANTY

Your new appliance is covered by a warranty. The warranty card is enclosed – if it is missing, you must provide the following information to your retailer in order to receive a replacement: date of purchase, model, and serial number. Registration can also be completed online by visiting www.caple.co.uk. Ensure you keep your warranty card safe, you may need to show it to Caple Service together with proof of purchase. If you fail to show your warranty card you will incur all repair charges. Spare parts are only available from Caple Service and spare parts authorized centers.

CE DECLARATIONS OF CONFORMITY

This appliance has been manufactured to the strictest standards and complies with all applicable legislation, Low Voltage Directive (LVD) and Electromagnetic Compatibility (EMC).
UKCA DECLARATIONS OF CONFORMITY
This appliance has been manufactured to the strictest standards and complies with all applicable legislation.

TECHNICAL FICHE

This appliance conforms to all current and applicable energy regulations. To view the Technical Fiche that supports the energy labeling data, please visit the product page on our website www.caple.co.uk

INSTALLATION

PREPARE FOR THE INSTALLATION

1. If you have an outlet to the outside, your cooker hood can be connected as per the below picture by means of an extraction duct with an interior diameter of 150mm.
2. Before installation, turn the unit off and unplug it from the outlet.
3. The cooker hood should be placed at a minimum distance of 65-76cm above the hob. It is the manufacturer of the hob who determines the clearance required and the clearance quoted by the hob manufacturer must be followed. In the absence of any instructions supplied with a gas hob, the minimum distance between the hob and the hood must be at least 760mm.

INSTALLATION – DUCTED

WARNING:

Observe the warning concerning the operation of the appliance when air is discharged from the room.

1. Position the hanging plate on the ceiling and then mark the position of the screw holes. The hanging plate should be securely fixed to the ceiling. 11 x ST6 (40mm) screws for wooden ceiling and 8 x expansion bolts for cement ceiling.

2. Fix the angle bars to the hanging plate, using the 8 x M5 screws.

3. Extend the angle bars to the required height and then fix them in position using the 16 x M5 screws and nuts with metal washers. IMPORTANT: The angle bars must have an overlap of at least 100mm.

4. If your cooker hood is going to be externally ventilated, then you should connect the ducting hose to the ceiling adaptor at this point. Fix the upper chimney section to the hanging plate, using the 4 x self-tapping screws. Slide the lower chimney section onto the angle bars and raise it until it sits just below the upper chimney section.

5. If the glass canopy has not been pre-assembled at the factory, then it should be fixed to the top of the main body of the cooker hood at this stage.

6. Lift the main body of the cooker hood onto the angle bars and then fix it into position using the 16 x M5 screws.
   IMPORTANT: This stage of the installation process MUST be completed by two people. The 16 x M5 screws MUST be securely tightened.

7. If you are using the hood in ducted / ventilation mode, you should fix the ducting hose to the ceiling.

• The electrical connection must correspond to the electrical requirement noted on the rating plate, which is placed inside the cooker hood. The appliance should now be connected to the electrical supply.
• Check that the appliance is operating correctly by selecting each speed and switching the light bulbs on and off.
• Remove the hanging hook and then slide the lower chimney section downwards, until it rests against the main body of the cooker hood.
• Use a stainless steel cleaner and polish the stainless steel sections of the appliance.
• If you are using the appliance in recirculation mode, then you should now fit the charcoal filter. See the “fitting the charcoal filter” section on page 14.
• Fix the one-way valve to the air outlet of the cooker hood. Then, attach the exhaust pipe onto the one-way valve as shown below.

INSTALLATION – RECIRCULATION MODE
If you do not have an outlet to the outside, the exhaust pipe is not required (as shown in the section “Installation – ducted”), and charcoal filters must be installed.

INSTALLING THE CHARCOAL FILTER (CAP61CF)
An activated charcoal filter can be used to trap odours. In order to install the charcoal filter, the grease filter should be detached first. Press the release button and pull it down as shown below. Fit the activated charcoal filter onto the side of the motor and turn it in a clockwise direction to lock it into place. Repeat the same on the other side.

Scan the QR Code to access the ‘How To’ video.

NOTE:

• Make sure the filter is securely locked. Otherwise, it may loosen and be dangerous.
• When using a charcoal filter, the extraction power may be slightly reduced.
• We recommend replacing these filters every 6 months. Replacement filters (CAP61CF) can be purchased directly from www.caple.co.uk

OPERATION – TOUCH CONTROL

• ON/OFF BUTTON
  Press and hold for 2-3 seconds to turn the extractor fan on. You can then change the speeds as per below. Press again to switch off.

• LOW-SPEED BUTTON
  Is suitable for simmering and cooking which does not produce much steam or odour.

• MEDIUM SPEED BUTTON
  Airflow speed is ideal for extracting with standard cooking.

• HIGH-SPEED BUTTON
  When a high amount of steam or odours is produced, use the high-speed setting for the most effective extraction.

• LIGHT BUTTON
  Switches the light on and off.

CARE AND MAINTENANCE

IMPORTANT:
Before cleaning or maintenance please switch off the electricity supply and remove the plug from the wall.
REGULAR CLEANING
Use a soft damp cloth with lukewarm mildly soapy water or household cleaning detergent. Never use metal pads, chemicals, abrasive material, abrasive cleaning creams, or stiff brushes to clean the appliance.
CLEANING THE GREASE FILTER
Clean the filter every month to help minimize the risk of fire. The filter collects grease, smoke, and dust, therefore the filter is directly affecting the efficiency of the cooker hood. If not cleaned, the grease residue (which is potentially flammable) will saturate the filter. It can be easily cleaned with warm water and washing up liquid, alternatively the filters can be cleaned in your dishwasher. Please ensure no other items are washed with the filters, they must be washed separately to prevent food from becoming trapped in the gauze. Cleaning the grease filters in the dishwasher may lead to discoloration, this is normal and is not a fault with the product.
REPLACING YOUR CHARCOAL FILTER
This only applies if you are using the hood in recirculation mode (not vented to the outside). The charcoal filter traps your cooking odours and they need to be replaced, this can vary depending on how frequently the cooker hood is used. We recommend replacing them at least every 6 months.

This extractor uses CAP61CF charcoal filters. Filters can be purchased directly from www.caple.co.uk.

REPLACING THE BULB

1. Switch the unit off and unplug the appliance.
2. Remove the lamp cover by unscrewing the 2 screws.
3. Replace with the same type and rated bulb/lamp fixing. LED lamp (max.1.5W).

NOTE:
The lights must be replaced by a qualified person.
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class G.

TROUBLESHOOTING

The lights are on, but the fan does not work

| The fan blade is jammed|

Switch off the unit and contact Caple Service. To be repaired by qualified service personnel only.

The motor is damaged

The lights and fan do not work| A blown fuse| Replace the fuse.
The power cord is loose| Plug into the power supply again.

Serious vibration of the unit

|

The fan blade is damaged

| Switch off the unit and contact Caple Service. To be repaired by qualified service personnel only.

The fan motor is not fixed tightly

| Switch off the unit and contact Caple Service. To be repaired by qualified service personnel only.
The unit is not hung correctly on the bracket| Take down the unit and check whether the bracket is in the correct location.
The extraction performance is not good| The filter requires cleaning| Clean the grease filter as directed in the ‘Care and maintenance section. Replace the charcoal filter (if in recirculation mode).

If the above table has not solved the problem please contact Caple Service by phone on 0117 938 7420 or by email service@caple.co.uk

PRODUCT DIMENSIONS

CGI921

Caple Service

• Fourth Way T: 0117 938 1900
• Avonmouth E: service@caple.co.uk
• Bristol
• BS11 8DW: www.caple.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>