FIAMMA 02094-38A Carry Bike Frame Crafter E-Bike Instruction Manual
- June 5, 2024
- FIAMMA
Table of Contents
FIAMMA 02094-38A Carry Bike Frame Crafter E-Bike Instruction Manual
Package contents
Installation instructions
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualifi ed personnel and in compliance with
current local regulations.
Installation only on right rear door
Not suitable for vehicles with 270° hinge system
Tighten the screws and ensuring that the rear door opens and closes correctly.
Instructions for use
In case of problems please contact your local dealer indicating the data on the nameplate. Consult our website for spare parts drawing.
[](https://www.fiamma.it/en/spare-parts-carry-bike/bike-carriers-for-van-
conversions/frame-crafter-e-bike-2006-02094-38a-aluminium-02094a38a-deep- black)
Safety instructions
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed.
In the event of an accident involving the vehicle and/or the product, ensure
that the product has not been damaged. In the event of damage, contact your
local retailer before moving the vehicle.
Fiamma declines every responsibility for any modification of the product that
may cause damage and/or injury to things and people.
Checking that the wall/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce these points.
After having positioned the Carry-Bike on the rear axle of the vehicle, the normal weight distribution on both axles would be modifi ed. This variation must not exceed the maximum permissible axle load.
Never exceed the maximum permitted length and the total weight of the full- load vehicle.
Make sure that loading occurs following a correct weight distribution; it must be uniformly distributed (the heaviest bike must be placed near the wall of the vehicle) to ensure better stability.
Always give warnings about the presence of the Carry-Bike on your vehicle, using a clearly signal for leaning loads and, in case of limited rear visibiliy, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during driving and expecially during reversing manoeuvres, particularly if you have parking assist system.
Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffi c conditions and towed load
In case of use of the bike carrier with tow make sure that the tow hook is always accessible and the corner mobility of the tow is guaranteed (volume measuring din 74058).
Check periodically the bicycle rack to make sure it is firmly attached, especially during the first kilometers of after long trips to avoid damages of the Carry-Bike/vehicle. Make sure the belts are not loose and that the holding brackets have not shifted. Replace worn components immediately.
During Carry-Bike installation, verify that there is enough distance between handlebars and/or pedals and the vehicle’s rear windows in order to avoid any damages of the window van; do not leave accessories attached (bay seats, baskets, etc) because vibrations could disengage bikes.
In some cases, the rear windscreen wiper may not work due to the presence of bicycles. Be aware of the brush radius before operating the windscreen wiper.
On this type of Carry-Bike, bike covers are not allowed (Bike Cover).
It is advisable to remove the batteries from bicycles, before loading them on the Carry-Bike while traveling.
Lower version must be used together with the number plate holder bar with regulation lights.
The geometric configuration of the Carry-Bike allows the rear door of the vehicle to be opened even with the bikes mounted.
It is recommended to rotate the handlebars of bicycles to avoid damage to the vehicle wall, for which Fiamma declines all responsibility.
Accessories
RAIL PREMIUM S
Item No. 98656M133
Item No. 98656M152
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifications and models or to cease production of any model.