displayride Model T Ride Share Experience User Guide
- June 3, 2024
- displayride
Table of Contents
Model T
User Guide
Product Features
Front Camera
In-Car Camera
Install Dashcam
Before you start, make sure that the vehicle is parked on a level surface and that the windshield is clean and dry.
- Insert SIM card and SD card .
- Place the camera as high as possible on the driver’s side of the vehicle.
- Remove the release paper of adhesive, and mount the dashcam to the windshield Id.
- Adjust the camera to the proper angle for taking, records.
- Connect the cables tightly at the ends, and Insert the cigarette lighter into the socket.
***DO NOT INSTALL THE PRODUCT IN A LOCATION WHERE IT CAN OBSTRUCT THE
DRIVER’S FIELD OF VISION.
*Some jurisdictions have regulations that prohibit or restrict where objects can be placed on the windshield. Be sure to comply with applicable law.
Test your Dashcam
- Insert the power cable into the dashcam. Start your vehicle to test if the dashcam is powered on. Once you tested your dashcam, run the power cable along the headliner of the car along the A-Pillar to the power source for a clean installation.
- That’s it. You’ve successfully installed your dashcam!
Remove Dashcam
- Power off the dashcam. § Disconnect the power cables. § Tuning the knob of the mount kit till it is loosened.
- Take the dashcam off the mounting board.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2A4Q3-RMP
Documents / Resources
|
displayride Model T Ride Share
Experience
[pdf] User Guide
RMP, 2A4Q3-RMP, 2A4Q3RMP, Model T, Model T Ride Share Experience, Ride Share
Experience, Share Experience, Ride Experience
---|---