Koopao EC618 3-In-1 Fast Charger Instruction Manual
- June 5, 2024
- Koopao
Table of Contents
Koopao EC618 3-In-1 Fast Charger Instruction Manual
Introduction
- Wireless charging area of mobile phone
- Charging of airpods/airpods pro.
- Wireless charging area of iWatch.
- Operating indicator light.
- TYPE-C Female
Operation instructions
2.1 Charging the mobile phone: Support the maximum phone thickness. Put the mobile phone upright in the wireless charging area of mobile phone, and you can see the “Charging indicator” on the display of the mobile phone, showing that it is being charged properly. (Attention: The phone cannot be charged when placed horizontally)
2.2 Charging the watch: Put the watch on the wireless charging area of watch, and align the magnets; the “Charging indicator” on the watch will light up, indicating that it is being charged properly.
2.3 Charging the Bluetooth headset: Insert the plug to the Bluetooth headset charging compartment (Attention: If a thick silicone protective cover is provided on the headset charging compartment, it may cause poor contact and failure to charge, please remove the silicone protective cover before charging.)
2.4 This product needs to be powered with an adapter with a power of 9V—2A and connected to the type-c port. When the bottom power indicator is on, it means that the power supply is connected.
2.5 Operating indicator: The blue working indicator is always on during the charging process of the mobile phone, which is off when it is not being charged or fully charged; it will flash in case of any charging fault.
Specifications
Matters needing attention
4.1 When charging the device, do not use a protective cover with a thickness of more than 5mm, and do not use a protective cover with a metal sheet.
4.2 Do not put metal foreign objects in the charging area.
4.3 When charging, please aim the device at the center of the charging area.
4.4 Contact: koopao_cust@163.com,
Customer satisfaction is our pursuit, if there are any quality problems please contact us first.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>